-=Z28=-
March 25, 2020
Made a jig table for helping to keep stuff straight when i remove brackets off this old 10 bolt. I was going to go all out and weld everything to the table, but i think instead im going to weld the brackets together on either side of housing, so when i cut them off they are 1 piece. As long as i replicate the angle and distance from housing end, i should be good to go. Anyone have any ideas? Rather not make some crazy jig, but will if needed.
More About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!