multiport to carb swap
#1
Thread Starter
Junior Member
Joined: May 2009
Posts: 10
Likes: 0
From: omaha ne
Car: 1988 camaro z-28
Engine: built 350
Transmission: 700r4
Axle/Gears: 323 one wheel wonder
multiport to carb swap
hey anybody out there please help me i have a 1988 camaro with the 2.8 multiport and switching over to carb v8 350 and have no ideas what wires to use or start over my disributer is mallory unilite unit with a holley fuel pump and holley carb the trans has already been switched over does anybody have any sugjestions use factory or scrap and start over this car is being totaly restored and trying to make as neat as possibile but now im left scratching my head on what to do thanks for any help or diagrams tom
Last edited by tom h; 05-21-2009 at 03:23 PM. Reason: v-8 swap not 6 cyl
#2
Moderator
iTrader: (14)
Joined: Mar 2000
Posts: 43,169
Likes: 36
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Welcome aboard thirdgen.org.
I'm afraid the Carburetor forum is dominated by V8 guys. I'll move this to the V6 forum where you're more likely to get help.
I'm afraid the Carburetor forum is dominated by V8 guys. I'll move this to the V6 forum where you're more likely to get help.
#3
Thread Starter
Junior Member
Joined: May 2009
Posts: 10
Likes: 0
From: omaha ne
Car: 1988 camaro z-28
Engine: built 350
Transmission: 700r4
Axle/Gears: 323 one wheel wonder
Re: multiport to carb swap
i didnt put up enough information 1 built a 350 for the car and cant figure what wires to use any help would be appreciated
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM