Idle up and down, stalling.
08-13-2004, 02:42 PM
#51
Junior Member
Thread Starter
Join Date: Jun 2003
Location: Bayarea
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
the EGR is still connected to the T/B, as are wireconnections.
I put a metal plate between the exhaust manifold and the EGR.
should i just go ahead a put a plate on the TB?
I put a metal plate between the exhaust manifold and the EGR.
should i just go ahead a put a plate on the TB?
08-13-2004, 04:35 PM
#52
Supreme Member
Join Date: Feb 2003
Posts: 1,287
Likes: 0
Received 1 Like
on
1 Post
Car: a car being parted out
Engine: blown up
Transmission: in peices
Originally posted by 90ekm
the EGR is still connected to the T/B, as are wireconnections.
I put a metal plate between the exhaust manifold and the EGR.
should i just go ahead a put a plate on the TB?
the EGR is still connected to the T/B, as are wireconnections.
I put a metal plate between the exhaust manifold and the EGR.
should i just go ahead a put a plate on the TB?
I would remove the EGR, and check to see if it is fully extended. That would mean it is closed. Then remove that plate, and replace the EGR, and remove the plug. That will keep it from operating.
How does your 02 sensor look?
Thread
Thread Starter
Forum
Replies
Last Post
