U-joint for ALuminum driveshaft
02-16-2006 | 06:51 AM
#1
Thread Starter
Member
Joined: Oct 2003
Posts: 306
Likes: 3
Car: 1991 GTA
Engine: SuperRam 350
Transmission: 700R4
Axle/Gears: 3.73
U-joint for ALuminum driveshaft
Hi everybody again! I recently broke the driveshaft's U-joint (rear)and haven't been able to find one for the aluminum driveshaft (JG1). They say it has been discontinued from GM and the only one they have is for the steel driveshaft which is different. I was looking at the universal U-joints from Presicion U-joints and think I might fond one for my application there. I'm not sure though. Question...Where can I find that joint? Is the U-joint from the LS1's driveshaft the same as mine? Thanks a lot!
02-16-2006 | 01:31 PM
#2
Supreme Member
Joined: Mar 2002
Posts: 1,654
Likes: 2
From: Lower Salford, PA
Car: 1987 Camaro Z-28
Engine: 6.3L Victor EFI
Transmission: Tremec TKO 600
Axle/Gears: Moser 9"/4.11 Trac-Lok
The GM # is 10147926 & is still available from VPI. Your GM dealer can order it from them. NAPA also carries this under pn UJ2400356.
Thread
Thread Starter
Forum
Replies
Last Post
10147926, 1988, 5676, aluminum, camaro, changing, driveshaft, driveshafts, gm, joint, joints, ls1, replacement, ujoint, ujoints
