700r4 Part Compatibility
#1
700r4 Part Compatibility
Converting '87 MAF to 90 SD. I've got a '90 SD harness, but the trans only has a 2k VSS.
I've read here that by changing the prom and repinning the harness I can run a 2k ppm on a 730 ECM ? The car wont have cruise and the dash will probably be a custom unit from dakota digital that I guess I can run on the 2k output from the ECM ?
If the above is not possible can I just by the 4k VSS and bolt it in to the trans or do they use different wheels inside the tailshaft ?
To put it another way, will the magnetic type VSS "read" the gear wheel inside an '87 trans ?
I've read here that by changing the prom and repinning the harness I can run a 2k ppm on a 730 ECM ? The car wont have cruise and the dash will probably be a custom unit from dakota digital that I guess I can run on the 2k output from the ECM ?
If the above is not possible can I just by the 4k VSS and bolt it in to the trans or do they use different wheels inside the tailshaft ?
To put it another way, will the magnetic type VSS "read" the gear wheel inside an '87 trans ?
#2
Supreme Member
![](https://www.thirdgen.org/forums/images/ranks/tgo10.gif)
iTrader: (4)
Join Date: Aug 2005
Location: louisville, ky
Posts: 1,366
Likes: 0
Received 0 Likes
on
0 Posts
Axle/Gears: '01 3.42 10 bolt
if the '87 trans has a reluctor on the shaft, then yes it will. my '87 trans has a gear drive on the shaft and the vss is on the back of the speedometer housing. you can pull the tail housing off the trans and replace the gear with a reluctor and the proper vss for the speed density set-up and go with that. but no, the magnetic type vss will not read off the gear wheel inside the '87 trans. it has to have a reludtor/pick-up to read off of.
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM