drilling out vb feed holes
#2
Supreme Member
Join Date: Jul 1999
Location: Calimesa, California, U.S.
Posts: 3,462
Likes: 0
Received 42 Likes
on
29 Posts
With the stock torque converter drill the 2nd gear feed to .086, .096 MAX! Drill 3rd feed to .110. If you get a chance call me, and I will be able to help you out on this a little better than I can here. 800 7763288 M-S 10-6 PST.
#3
tv sleeve
i plugged the 2 holes in the sleeve (the 2 in the u shaped cutout,
180 degrees apart from each other)
the tranny still kicks dowm into 3rd gear
after drilling the vb and plugging the accumulator feed hole
the 3-4 shift is much better
any idea why it still kicks down into 3rd?
180 degrees apart from each other)
the tranny still kicks dowm into 3rd gear
after drilling the vb and plugging the accumulator feed hole
the 3-4 shift is much better
any idea why it still kicks down into 3rd?
#6
isnt it supposed to stay in 4th no matter how much throttle you give it
or is that above certain speeds
how about the 3-4 full throttle shift, will it be able to
or do i have to modify something else to get it to do this?
or is that above certain speeds
how about the 3-4 full throttle shift, will it be able to
or do i have to modify something else to get it to do this?
Thread
Thread Starter
Forum
Replies
Last Post