TPS adjustment
02-09-2004, 02:47 PM
#1
Member
Thread Starter
Join Date: May 2002
Location: Toledo Ohio
Posts: 459
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 firebird and 95 trans am
Engine: LO3 and LT1
Transmission: 700R4-4l60E
TPS adjustment
when i am adjusting my TPS what two wires do i use to get the voltage reading on my meter
02-10-2004, 12:43 AM
#2
TGO Supporter
Join Date: Oct 2003
Location: ready room
Posts: 2,069
Likes: 0
Received 0 Likes
on
0 Posts
Car: NCC-1701-D (docked in AZ)
Engine: impulse drive
Transmission: fusion reactors
Axle/Gears: Rescued from the Borg by my crew
The top two. Negative on top and then positive underneath it (which is the middle wire on tps).
06-08-2004, 10:16 AM
#4
Supreme Member
Join Date: Oct 2001
Location: Louisville, Ky
Posts: 3,155
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Z28
Engine: 383
Transmission: T-5
Axle/Gears: 3.08 10 Bolt
TTT i got what wires i need to test but what exactly do i need to do to adjust this? also, what should it be reading?
06-09-2004, 12:31 AM
#6
Supreme Member
Join Date: Oct 2001
Location: Louisville, Ky
Posts: 3,155
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Z28
Engine: 383
Transmission: T-5
Axle/Gears: 3.08 10 Bolt
very nice 
i just figured i would post a question while i was searching. just a little later on i found the same exact thing you posted!!! thanks for the link tho
i just figured i would post a question while i was searching. just a little later on i found the same exact thing you posted!!! thanks for the link tho 
Thread
Thread Starter
Forum
Replies
Last Post
