Desktop dyno programs

Reply Subscribe

Thread Tools

Search this Thread

01-19-2003, 07:56 PM

Swapmaster

Senior Member

Thread Starter

Join Date: Mar 2002

Location: Somewhere over the rainbow

Posts: 792

Likes: 0

Received 4 Likes on 3 Posts

Desktop dyno programs

What desktop dyno programs are you guys running?

I have DD2000 and Virtual Engine Dyno v3.0.9 installed and the Virtual Engine Dyno v3.0.9 blows DD2000 out of the water. It's not even close. You can find Virtual Engine Dyno v3.0.9 at http://www.virtualengine2000.com/Vir...neDynoTour.htm

You can set every aspect down to how thick the head gasket is.

Reply Like

01-19-2003, 08:31 PM

ontogenesis

Supreme Member

Join Date: Oct 2002

Location: Las Vegas, NV

Posts: 1,641

Likes: 1

Received 1 Like on 1 Post

Car: 1985 Camaro, 2015 Audi A4

Engine: V8

Transmission: 700R4

if you use dd2k, you'd know that you can set head gasket thickness in it too

Reply Like

01-19-2003, 08:39 PM

Morley

Supreme Member

Join Date: May 2002

Posts: 4,099

Likes: 0

Received 2 Likes on 2 Posts

Yeah, There's not much DD2k can't do if you look at all of the avialable options/tools.

Reply Like

01-20-2003, 07:30 AM

Swapmaster

Senior Member

Thread Starter

Join Date: Mar 2002

Location: Somewhere over the rainbow

Posts: 792

Likes: 0

Received 4 Likes on 3 Posts

Yea, I was digging around in DD2000 last night and found it.
I set up the same engine in both programs and I think Virtual Engine showed more realistic curves but DD2000 showed more realistic numbers. but both show what component changes do to the numbers though and that's what it's all about I guess. Although Virtual Engine is much simpler to set up and to customize parameters.

Last edited by Swapmaster; 01-20-2003 at 07:33 AM.

Reply Like