How does this cam sound?
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Under the hood.
Posts: 951
Likes: 0
Received 0 Likes
on
0 Posts
How does this cam sound?
Just looking at the Lingenfeter site and came across this cam:
224/234 .496/.520 112LSA
Do you think it is too radical for stock heads?
Should i go with this:
214/224 472/496 112lsa
Will have headers, 2800stall, and other small bolt on's as well.
224/234 .496/.520 112LSA
Do you think it is too radical for stock heads?
Should i go with this:
214/224 472/496 112lsa
Will have headers, 2800stall, and other small bolt on's as well.
#2
Member
iTrader: (1)
Join Date: Apr 2002
Location: Indiana
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
Car: Golden yellow 1987 IROC-Z
Engine: L98
Transmission: 700R4
Axle/Gears: 3.27
That is the ZZ9 TPIS cam right? If it is that is a good cam for mid range torque, but you will need new springs. You wont get full potential out of it till you do an intake and runners swap. But it is a very good street/performance cam. Hope this helps alittle.
Sleeper_Z
1987 IROC-Z
350TPI (internaly stock)
700R4 w/shift kit and vette mods
9-bolt w/3.27's
Mods:
Edelbrock T.E.S.
no converter, flowmaster cat back
K&N's, ported upper plenum,
Holley air foil, Crane AFPR @48psi,
Olson race Cars SFC's, Eibach springs,
Poly bushings and mounts
Best R/T .503
Best 60' 2.03
Best 1/8 9.23@75
Best 1/4 14.44@97.34
Sleeper_Z
1987 IROC-Z
350TPI (internaly stock)
700R4 w/shift kit and vette mods
9-bolt w/3.27's
Mods:
Edelbrock T.E.S.
no converter, flowmaster cat back
K&N's, ported upper plenum,
Holley air foil, Crane AFPR @48psi,
Olson race Cars SFC's, Eibach springs,
Poly bushings and mounts
Best R/T .503
Best 60' 2.03
Best 1/8 9.23@75
Best 1/4 14.44@97.34
#3
Supreme Member
Join Date: Sep 1999
Location: Ohio, USA
Posts: 1,054
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2015 Camaro Z/28 & 2013 Super Bee
Engine: LS7 and 392 HEMI
That Lingenfelter cam is too big to use with the stock tpi and heads, that cam is more suited to a Holley Stealth Ram or LT1 intake.
The 214/224 cam you list sounds ok, I wouldn't go with any cam that has larger duration with a long tube runner tpi setup.
The 214/224 cam you list sounds ok, I wouldn't go with any cam that has larger duration with a long tube runner tpi setup.
Thread
Thread Starter
Forum
Replies
Last Post