Tech / General Engine - Page 266 - Third Generation F-Body Message Boards

New Thread Subscribe

Filters

Page 266 of 2005

266

Threads in Forum: Tech / General Engine

Forum Tools Search this Forum

Thread / Thread Starter

Last Post

Replies

Views

305 fresh heads run-ability issues

smgseanmicheal on 12-19-2012

01-03-2013 12:15 PM
by smgseanmicheal

780

2200rpm, car, carb, edelbrock, geo, great, high, load, metro, missing, quadrajet, rpm, runs, starts, stutter, stuttering

350 swap engine stutters after 2200 rpm

xsive7272 on 12-31-2012

01-03-2013 09:40 AM
by xsive7272

1,541

1983, 305, 318, block, broke, broken, cracked, d150, located, oil, plug, pressure, sending, summerfield, switch, unit

broken oil pressure sending unit

KuroNeko on 01-02-2013

01-03-2013 08:16 AM
by KuroNeko

1,629

barely, bolted, car, engine, hand, hard, locked, smokes, start, starter, transmission, turn, turns, up, wrong

won't turn over

steeljab on 02-05-2008

01-02-2013 10:38 PM
by zaxan

3,089

Informative link with aftermarket part dyno #s

IROCZ1989 on 01-02-2013

01-02-2013 09:43 PM
by IROCZ1989

322

car broke down again..

JesseShredd on 01-02-2013

01-02-2013 08:24 PM
by zraffz

567

50l, 86, 89, cold, crank, day, extend, gas, initial, injector, iroc, long, pedal, press, sputter, sputtering, start, starting, thirdgen, time, z28

extended start and sputtering

blue iroc on 12-18-2012

01-02-2013 06:54 PM
by ex-x-fire

2,427

UNDER HEADER PLUG LEADS

CAMAROBEAV on 01-02-2013

01-02-2013 06:44 PM
by 8t2 z-chev

438

1988, 28l, 86, 88, camaro, crank, cranks, fine, gas, pushing, ran, start, v6, wont, z28

88 camaro won't start

blancocamaro on 12-28-2012

01-02-2013 06:25 PM
by blancocamaro

2,248

Car clicks and sometimes starts

JLCustomizing on 01-01-2013

01-02-2013 10:37 AM
by 2007xl50

808

AC/HEATER/SMOG GONE

rockin the z on 01-02-2013

01-02-2013 09:03 AM
by rockin the z

458

new to this need some help, thanks

69boss429man on 12-30-2012

01-02-2013 07:42 AM
by 69boss429man

602

85 power steering

rockin the z on 01-02-2013

01-02-2013 07:38 AM
by Edwardgp

618

Whats the safest way to Jack it up far enough to do a sending unit/pump

86FyrBrd on 12-30-2012

01-02-2013 07:24 AM
by Ozz1967

629

WARM ENGINE TROUBLE IDLING AND MAKING A LIGHT PUTTING NOISE

blake2048 on 01-01-2013

01-02-2013 07:02 AM
by Ozz1967

571

312, 5050, b12, chemtool, coming, cylinder, ford, oil, past, pressures, rings

Pulled plugs, Checked Compression- need your opinion!

HawkZ28 on 10-21-2010

01-02-2013 06:56 AM
by HawkZ28

1,694

oil leak problem

everzack on 01-01-2013

01-02-2013 01:44 AM
by JesseShredd

466

heads, intake, large, reduce, runner, runners, volume, wepoxy

Is it possible to reduce larger runner heads volume?

toomanytransams on 12-31-2012

01-01-2013 10:54 PM
by cuisinartvette

721

70pmh, correct, high, rpm, rpms, running

RPMS running too high

jherrera1341 on 12-31-2012

01-01-2013 08:58 PM
by jherrera1341

701

need some flexplate help

Gsoleski on 12-29-2012

01-01-2013 09:44 AM
by Gsoleski

564

14014434, 43gm14010207, casting, chevrolet, code, corvette, decode, engine, gm, info, intake, manifold, overhaul, stampings, twf, v0504tfw

Decoding Engine

armybyrd on 12-28-2012

01-01-2013 09:28 AM
by sofakingdom

9,276

Whats my engine???

CAMAROBEAV on 12-23-2012

12-31-2012 08:31 PM
by skinny z

1,225

2101, block, center, edelbrock, gasket, gaskets, hold, intake, make, manifold, metal, passage, pieces, silicone, transmission, water

How do I get intake manifold gaskets to set..?

calgutie on 12-16-2012

12-31-2012 03:59 PM
by calgutie

4,545

Exhaust and engine accoustics for asthetics and performance

faytmorgan on 12-30-2012

12-31-2012 09:29 AM
by cuisinartvette

808

a few questions on various topics

highgear on 12-30-2012

12-31-2012 08:30 AM
by highgear

469

blaster, bumps, bushing, car, diagnose, end, front, moog, noise, noisepb, speed, steering, strut, thermoplastic

Front End/Steering Noise. Help Me Diagnose!

FireDemonSiC on 12-29-2012

12-31-2012 12:47 AM
by jermdm

1,143

1984, 305, 327, 59cc, air, bad, bore, connecting, cylinder, force, gain, good, headers, heads, horsepower, l69, parts, rods, tpi

Major parts list for a L69 overhaul.

Chuck84TA on 11-20-2012

12-30-2012 04:00 PM
by HighPressure

3,751

Any ideas what this is???

rws981 on 12-29-2012

12-30-2012 06:55 AM
by rws981

528

3478, 3rd, 78, 87, battery, camaro, fbody, fit, gen, group, optima

Will This Battery Fit?

armybyrd on 12-29-2012

12-29-2012 10:24 PM
by AlkyIROC

2,087

85, camaro, humming, motor, noise, sound

Very Annoying Humming Sound

tylerf on 12-27-2012

12-29-2012 08:56 PM
by unseenT/A

798

Small Cap Swap; Wire Orientation Question

LGAFF on 12-29-2012

12-29-2012 07:53 PM
by LGAFF

517

305, 350, air, car, chevy, end, engine, exhaust, hot, lean, popping, running, sbc, side, valves

Exhaust getting too hot, valves?

blue birdy 87 on 12-28-2012

12-29-2012 11:35 AM
by Confuzed1

22,578

305, 98, block, blocked, chevy, corvette, gasket, gasketblock, intake, manifold, plate, plates, port, sbc, tpi

Intake manifold block off plate?

cactusman92 on 12-28-2012

12-28-2012 09:21 PM
by cactusman92

2,861

1, 115, 1151, 93, afr, calculator, compression, fuel, heads, highest, ir0n, iron, octane, ratio, timing

11.5/1 compression on 93 octane?

FConn3 on 12-24-2012

12-28-2012 05:40 PM
by SuperRamFormula

24,913

1988, 87, beginner, budget, build, firebird, ideas, project

Want to build a firebird

ElQuesoBandito on 12-28-2012

12-28-2012 05:36 PM
by ElQuesoBandito

813

Occassional No-Start

hdis2002 on 12-28-2012

12-28-2012 04:24 PM
by hdis2002

405

2k, 50, cam, cammed, car, carburetor, engine, glow, glowing, headers, idle, red, rpms, setging, timing, transmision, wont

New cam...glowing red headers, wont idle under 2k rpm

85ZBLUE on 12-23-2012

12-28-2012 05:19 AM
by 85ZBLUE

1,282

should I be concerned??

scoflaw on 12-21-2012

12-27-2012 09:30 PM
by FtrSpeedy

472

92 camaro wont start

MI_AMOR_2010 on 12-27-2012

12-27-2012 08:47 PM
by skirkland1980

483

car, distributer, distributor, tube, vacum, vacuum

Vacuum tube for Distributor

djjon76 on 12-26-2012

12-27-2012 08:09 PM
by TreeFiddy

689

350, 88, cam, cams, gen, iii, kind, lt1, motors, work

will a lt1 cam work in a pre 88 350?

jugheads88gta on 12-27-2012

12-27-2012 02:28 PM
by ninetyone

1,073

1227165, 57, 90, coil, cost, distributor, ecm, fuel, injector, injectors, pick, port, pulse, tpi, tuned, work

5.7 tpi no injector pulse

gta power on 12-25-2012

12-27-2012 11:54 AM
by gta power

13,600

Camshaft Question.

Jake_92RS on 12-27-2012

12-27-2012 06:26 AM
by vetteoz

477

Ignition Switch Mechanical Problem 92 RS

LarryD on 12-22-2012

12-26-2012 10:15 PM
by LarryD

448

spring rate on motown 220s

355sleeper on 12-26-2012

12-26-2012 09:40 PM
by 355sleeper

522

FREE Online Repair Guides; How-To's; Wiring Diagrams

SR-71 on 12-26-2012

12-26-2012 08:37 PM
by eseibel67

710

speedometer question.

mickcamaro91 on 12-23-2012

12-26-2012 03:55 PM
by NINÅ

411

10, 111, 70cc, 76cc, builds, chambers, compression, cr, cylinder, engine, head, heads, iron, mill, piston, time

10:1 76cc, to 70cc heads bad idea?

JesseShredd on 12-23-2012

12-26-2012 02:40 PM
by DeltaElite121

5,794

Wont start when hot and needs starting fluid to fire

gta/formula on 12-26-2012

12-26-2012 12:00 PM
by skirkland1980

665

2012, 3400, aluminum, automotive, block, camaro, cast, engine, heads, iron, lift, lifting, ls1, points, trans

Engine Lift Points

oscarfromla on 12-02-2012

12-25-2012 05:02 PM
by oscarfromla

21,009

Page 266 of 2005

266

New posts

No new posts

Thread is closed

Hot thread with new posts

Hot thread with no new posts