i gotta problem with my starter...people say its my selonoid?
#1
Thread Starter
Supreme Member
iTrader: (1)
Joined: May 2001
Posts: 1,638
Likes: 0
From: Greenwood, Indiana
Car: 1984 Trans Am
Engine: Vortec 355
Transmission: TH-700R4
Axle/Gears: GM Axles and GM 3.73
i gotta problem with my starter...people say its my selonoid?
when i try and start my car it will crank a couple times then it will sound like the starter is missing the flywheel and u can hear the starter rev up really high........it does this all the time if i dont start within a couple cranks.......some people told me it is my selonoid??......is it?
or is it something else?
thanks
or is it something else?
thanks
#5
I have had a lot of problems with my started until I discovered that a bracket was missing. It would keep kicking sideways throwing off the spacing and causing it to grind the teeth. Adjust / install your starter so that it works and measure the gap. If it starts to grind, measure the gap again. If it is in fact moving, you will need to find or make a bracket to keep your starter from pivoting on it's mounting bolts. This is what I did after going through 5 different starters and now I have no problems with it at all.
#6
Supreme Member
Joined: Dec 2000
Posts: 1,536
Likes: 0
From: Springfield, MO, USA
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
Definitely sounds like the bendix or solenoid to me too. As mentioned earlier, you can get a rebuilt starter with lifetime warranty very cheap.
Thread
Thread Starter
Forum
Replies
Last Post