Fire through tbi after distributor change
02-18-2014, 08:03 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2012
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Fire through tbi after distributor change
made two post the other day about problems with the car running bad and discovered the distributor was bad and the rotor was barely hanging on and burnt up. so I changed them. now when i turn the car over im getting fire through the top of the tbi. I did put the shaft in with the rotor lined up pointing to the #1 cylinder. any suggestions??
02-18-2014, 08:15 AM
#2
Supreme Member
iTrader: (-3)
Join Date: Dec 2012
Posts: 1,184
Likes: 0
Received 1 Like
on
1 Post
Car: 1991 firebird
Engine: TBI 305 (built)
Transmission: T5
Axle/Gears: 4.10
made two post the other day about problems with the car running bad and discovered the distributor was bad and the rotor was barely hanging on and burnt up. so I changed them. now when i turn the car over im getting fire through the top of the tbi. I did put the shaft in with the rotor lined up pointing to the #1 cylinder. any suggestions??
Sent from my XT907 using IB AutoGroup
02-18-2014, 07:49 PM
#7
Senior Member
iTrader: (8)
Join Date: Aug 2011
Location: Texas
Posts: 661
Likes: 0
Received 7 Likes
on
7 Posts
Car: 91 Firebird/88 Firebird/91 Formula
Engine: V6 3.1/V8 5.0/V8 5.0
Transmission: 4L60/700R4/4L60
Axle/Gears: 3.23/2.73/2.73
Re: Fire through tbi after distributor change
Did your fuel injector connectors look like this afterwards? Just curious. Was wondering what happened to mine.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM
