Temp capping off fuel lines
#1
Thread Starter
Member
iTrader: (1)
Joined: Jun 2007
Posts: 318
Likes: 0
From: Halifax, N.S.
Car: 89 T/A
Engine: LB9
Transmission: W/C T-5
Axle/Gears: 10 bolt posi, 3.73 Richmond Gears
Temp capping off fuel lines
Hey Guys,
I'm installing new heads and intake, I've capped off the fuel lines with vacuum hose caps and taped them up with electrical tape.
Is there a better way to do this, as I'm working on the top end when I get time and don't want a puddle of gas under the car.
Thanks
Follow up question, one of lines is a vent line....should this not be capped?
I'm installing new heads and intake, I've capped off the fuel lines with vacuum hose caps and taped them up with electrical tape.
Is there a better way to do this, as I'm working on the top end when I get time and don't want a puddle of gas under the car.
Thanks
Follow up question, one of lines is a vent line....should this not be capped?
Last edited by 89transam*pearl; 06-19-2012 at 11:52 AM. Reason: follow up question
#2
Supreme Member
Joined: Jul 2009
Posts: 2,328
Likes: 8
From: Kitchener, ON
Car: 1988 GTA
Engine: LB9
Transmission: T5
Axle/Gears: 3.45
Re: Temp capping off fuel lines
I capped them and the fuel expanding with heat in the tank popped them off and made a mess. Then I joined the supply and return lines with a short piece of hose and some clamps and it was all good.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
AkDrifted
Engine/Drivetrain/Suspension Parts for Sale
6
08-17-2015 07:45 PM