converting to roller, questions
#1
Thread Starter
Member
iTrader: (1)
Joined: Mar 2007
Posts: 183
Likes: 0
From: Union Beach, NJ
Car: 1984 Z28
Engine: 360ci SBC
Transmission: WC T5
Axle/Gears: 9 bolt 3.27 Posi
converting to roller, questions
ok, im converting from my hydraulic flat tappet setup to a roller setup (havnt decided yet if i want to go for hyd.) and i had just bought new +.100 pushrods for my new heads, my question is are there roller lifters close enough in height to match my new pushrods, or will i have to take the hit and try to sell these?
#3
Thread Starter
Member
iTrader: (1)
Joined: Mar 2007
Posts: 183
Likes: 0
From: Union Beach, NJ
Car: 1984 Z28
Engine: 360ci SBC
Transmission: WC T5
Axle/Gears: 9 bolt 3.27 Posi
Re: converting to roller, questions
yea, i know, im not even sure why i asked, i was hoping maybe someone thought to make some sort of short one.
oh well, its not a huge loss. ive had worse with this car. thank you.
oh well, its not a huge loss. ive had worse with this car. thank you.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM