Gauge needle problem.
07-19-2008 | 01:32 AM
#1
Thread Starter
Junior Member
Joined: Jul 2008
Posts: 34
Likes: 0
From: Boringville, USA (Ishpeming, MI)
Car: 1982 Camaro Z28
Engine: 4bbl 305
Transmission: 700R4
Axle/Gears: 10 bolt posi
Gauge needle problem.
Once in awhile my fuel gauge needle will move to other side of gauge and sit there. Idk if its old tech or faulty wiring? It eventually goes back to normal upon startup. Just recently my temp gauge did it too, i flicked the lense a few times and it went back to normal. Idk the problem.
07-19-2008 | 07:43 PM
#2
Supreme Member
iTrader: (3)
Joined: May 2005
Posts: 1,942
Likes: 0
From: Southern IL
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
Re: Gauge needle problem.
there is a ground wire that runs along the inside of the drivers door
clean it up and repost
clean it up and repost
07-19-2008 | 07:46 PM
#3
Thread Starter
Junior Member
Joined: Jul 2008
Posts: 34
Likes: 0
From: Boringville, USA (Ishpeming, MI)
Car: 1982 Camaro Z28
Engine: 4bbl 305
Transmission: 700R4
Axle/Gears: 10 bolt posi
Re: Gauge needle problem.
Ok ill try it thanx. I was thinkin it was a ground wire.
Thread
Thread Starter
Forum
Replies
Last Post
