Serp power steering pulley removal

Reply Subscribe

Thread Tools

Search this Thread

05-04-2008, 09:17 PM

jakesTA87

Junior Member

Thread Starter

iTrader: (1)

Join Date: May 2007

Location: Louisville, KY

Posts: 28

Likes: 0

Received 0 Likes on 0 Posts

Car: 87 Trans Am

Engine: 350(5.7L)

Transmission: WC T5

Axle/Gears: Junk 2.73s

Serp power steering pulley removal

can someone please educate me on how to remove the power steering pump pulley from a serpentine style setup...i need to get it off asap...do i need a puller of some sort?????????

Reply Like

05-04-2008, 10:11 PM

InfernalVortex

Supreme Member

iTrader: (4)

Join Date: Dec 2005

Location: Macon, GA

Posts: 6,489

Likes: 3

Received 21 Likes on 18 Posts

Car: 1992 Camaro RS

Engine: Vortec headed 355, xe262

Transmission: T56

Axle/Gears: 9-bolt 3.70

Re: Serp power steering pulley removal

Yeah there's a special puller you'll need. It's a little goofy but it's a big bolt that butts up against the center of the PS pulley (not the pulley itself, but the part that the pulley is mounted on) and you put a goofy grabber onto the outside of the bolt that holds onto a lip on the front of the pulley itself. You use a pair of wrenches and painstakingly screw it off. It's a pain in the ***, but not impossible by any means!

Make sure you get an installer tool too.

The puller is the large cylindrical thing on the top right near the box, and the installer is the one right beside it on the left. Im honestly not too sure what the othr stuff is, I didnt need them.

Last edited by InfernalVortex; 05-04-2008 at 10:14 PM.