Minimum rocker stud length...
#1
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2001
Posts: 1,520
Likes: 0
From: 600 yds out
Car: Bee-Bowdy
Engine: blowd tree-fity
Transmission: sebin hunnerd
Axle/Gears: fo-tins
Minimum rocker stud length...
I'm using Comp Pro Magnum roller rockers (7/16" stud) and the matching poly locks. What is the minimum amount (length) of rocker stud I need in the poly lock?
I'm concerned that I do not have enough rocker stud thread in the poly lock. The set screw is almost half way down in the nut. I measured and I have .325" rocker stud thread in the poly lock (out of .575" usable).
I had a bad experience once where the top of a rocker stud snapped off. I think this was the problem then.
I'm concerned that I do not have enough rocker stud thread in the poly lock. The set screw is almost half way down in the nut. I measured and I have .325" rocker stud thread in the poly lock (out of .575" usable).
I had a bad experience once where the top of a rocker stud snapped off. I think this was the problem then.
#2
Re: Minimum rocker stud length...
This thread may help. https://www.thirdgen.org/forums/tech...ro-magnum.html
Last edited by Kurt04; 10-16-2007 at 03:21 AM.
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
09-28-2015 12:35 AM
355tpipickup
Tech / General Engine
9
09-13-2015 11:35 PM