cleaned the engine... now running rough
#1
Member
Thread Starter
Join Date: Feb 2006
Location: Dallas, Texas
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
Car: '88 GTA
Engine: L98 -350TPI
cleaned the engine... now running rough
I sprayed the engine yesterday with engine cleaner then washed it off with the hose... I dried as much off as i could with a towel and then let it sit over night. This morning i reconected the battery and started the car... let it idle for 15 min and then tried driving it. At first the car was having trouble shifting to the next gear... the engine would cut out right before it would shift... and it would die at around 38mph. After driving it a little while i was able to get it up to 45 mph and it wouldnt die and the cutting out right before the shifting stopped. But Now it just randomly cuts out while im driving and will occationally die when its stopped. It seems like theres not enough fuel getting through. Sooo water went somewhere it wasnt supposed to... I need help!
Last edited by Beachmonkey6; 05-31-2007 at 04:11 PM.
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 36 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
You probably have condensation under your distributor cap. Could also be wet plug wire connections.
#3
Member
Thread Starter
Join Date: Feb 2006
Location: Dallas, Texas
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
Car: '88 GTA
Engine: L98 -350TPI
Re: cleaned the engine... now running rough
i took the dist. cap off and its all dry under there. I took the car out again and it drove and accelerated perfectly until it hit 34mph then it started cutting out again. When im driving i can throw it into neutral and rev it as high as i want and there is no problem, just when its in drive. There has to be some sensor or something of the sort that isnt working... ?
#4
Supreme Member
Join Date: Oct 2006
Posts: 1,974
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 RS
Engine: 350 vortec
Transmission: T-5
Axle/Gears: not the best not the worst
Re: cleaned the engine... now running rough
not sure about auto trannys but couldnt the torqe converter do that if it was locked up or can it only lock above 45?
#5
Member
Thread Starter
Join Date: Feb 2006
Location: Dallas, Texas
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
Car: '88 GTA
Engine: L98 -350TPI
Re: cleaned the engine... now running rough
this morning the car started up then immediately died. I restarted it and gave it a little gas and the car ran great up past 50 mph... but then after15 min of driving it i parked it and turned the engine off for 5 min.... Turned it back on and it was idling like crazy... the rpms were shooting up to 2000 and then back down to 500(500 is normal). Then the car kept surging while i was driving it... but never cut out or anything. The problem seems to be getting better... but i dont think its gonna fully go away without some help. What are yalls ideas?
#7
Junior Member
Join Date: May 2007
Location: Fredericksburg VA
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 IROCZ 350
Engine: 355 cu TPI
Transmission: 4L60 w/ 3200 stall
Axle/Gears: 9 bolt W/370 gear
Re: cleaned the engine... now running rough
Make sure that your dist. and al the connections are dry specially with an MSD box. I had the same problem with my 400 hp Integra. The MSD 6 BTM got wet when I wash the engine and the car will run for a few and them will start missing and then cut off and will not start for a long wile.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM