Running Lean After Rebuild
#1
Thread Starter
Supreme Member
iTrader: (2)
Joined: Jul 2004
Posts: 1,678
Likes: 0
From: Miami
Car: 1992 Camaro RS
Engine: L03
Transmission: 700R4
Axle/Gears: Stock
Running Lean After Rebuild
Okay, the Camaros been on jack stands for about a month now, and it's finally running again. Unfortunately, it's throwing a code 44 (running lean) at me and running a little rough at idle. Here's what I did: replaced the rod bearings, piston rings, had heads cleaned and resurfaced, and replaced all gaskets from the heads up. I also added an open element air cleaner.
Now the car was running just swell a month ago before the rebuild. So why would it act up now? Can the computer not compensate for the air cleaner and cleaned heads? Can I ramp up the fuel pressure myself? Thanks in advance.
Now the car was running just swell a month ago before the rebuild. So why would it act up now? Can the computer not compensate for the air cleaner and cleaned heads? Can I ramp up the fuel pressure myself? Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
GVMV
Engine/Drivetrain/Suspension Wanted
1
08-16-2015 08:01 PM