Theoretical Head Question
#1
Thread Starter
Supreme Member
Joined: Feb 2005
Posts: 1,034
Likes: 0
From: Fort Lauderdale, FL
Car: 91 Camaro RS
Engine: 305 TBI
Transmission: 700R4
Axle/Gears: 2.73 Posi w/Disc
Theoretical Head Question
Just was wondering if any GM DOHC heads can physically fit on the GEN I SBC block? I know it would be hell to fabricate a setup to replace the cam/pushrods/etc, but all I'm wondering is will the heads themselves fit? Bolt patterns, coolant passages, etc...
#2
Supreme Member
Joined: Jul 2001
Posts: 3,931
Likes: 0
From: Palm Bay, Florida, USA
Car: 95 E-150 & 07 Kawasaki ZX-6R
Engine: A slow one & a fast one
Transmission: A bad one & a good one
Axle/Gears: A weak one & a chained one
DOHC heads.......on a pushrod block......
Uhm......ehh???
Uhm......ehh???
#4
Junior Member
Joined: Jan 2006
Posts: 27
Likes: 0
From: sthlm sweden
Car: camaro
Engine: 377sb 400++hp
Transmission: tko 600
guess this is the closest you get.. and its not http://cgi.ebay.com/ebaymotors/ZR1-L...36948996QQrdZ1
#5
Supreme Member
Joined: Jul 1999
Posts: 1,551
Likes: 25
From: Adrian, Mi, USA
Car: 1988 Pontiac Firebird Formula
Engine: 5.7 TPI
Transmission: 700R4
Pete Ardema made an OHC conversion for stock chevy heads. (single). And there was also a three valve head from some other company. Not cheap though.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM