EGR block off plate?
11-11-2001, 01:59 PM
#1
Member
Thread Starter
EGR block off plate?
I am going to be putting Vortec heads and SDPC tpi base on soon. Would I be ok making my own EGR block off plates by cutting a piece of sheet metal to fit? I know the whole argument for keeping it and I have decided it is not worth the trouble. I will also have a custom chip, so no worry about codes. Anyway, can I just make this plate, or is there something more to it than a flat sheet of metal? Thanks.
------------------
-='89 Iroc-Z - 350 TPI =-
------------------
-='89 Iroc-Z - 350 TPI =-
11-11-2001, 02:13 PM
#2
Moderator
Join Date: Jan 2000
Location: Mercedes Norte, Heredia, Costa Rica
Posts: 20,981
Likes: 0
Received 9 Likes
on
8 Posts
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
I just asked about this a little while ago. A flat piece of metal should be fine.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
rudolphschenker
Transmissions and Drivetrain
1
09-04-2015 02:41 AM
