I just ordered a Painless Wiring Engine Harness kit from them which ran me $289.00 and no its not the one with extra 8 feet length, My question is this. How is the quality, anything i should look for before installing, the harness is for 86'-89' TPI w/ MAF. ITs going into an 92' body. IM using an 87 ENgine. Give me as much details as u possibly can thanx

 

I used one on my 89 RS convt when I put the L98/TPI motor in. The quality is excellent, no complaints other than mine was too short.

------------------
Rob P
89RSconvtZZ4TPI Edelbrock Intake
SLP Dual Cold Air Intake 1 5/8" Headers Semi-Siamesed Runners, IROC
suspension, alum shaft. Numerous mods.
92Z28convt5spd (stock)
71Impala convt 402BB
BETTER DRIVING THRU SUPERIOR HORSEPOWER!

 

If it was too short how did u remedy it? What did u do????????????????????

 

He probably cut each wire and soldered an extension in. Does anyone think it's worth the extra $$$ to get the thing 4' longer?

 

its not 4" longer its 8" longer the 4" longer is for TBI's

 

I agree...High quality. I also didnt have the longer harness. I used it to convert an 89 TBI to 88 TPI.

------------------
*1989 RS
*Red, Daytona Turbo fiberglass hood, chrome 16x8 IROC wheels
*355 CID
*TPI ported plenum, SLP siamesed runners, Edelbrock high flow intake
*SLP 1 and 3/4 headers with 3 inch catback being installed next week
*Richmond 3.73, Auburn Posi
*Modded 700-R4, 2800 stall converter
*eibach pro kit and hotchkis sturt tower brace