Widening stock gaskets...
#1
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jul 1999
Posts: 2,260
Likes: 0
Car: 87 Camaro
Engine: Chevy V8
Transmission: auto
Widening stock gaskets...
One of my runner gasket is wrecked..Is it OK for me to just get stock gaskets and dremel it to fit..
reasons for going this route:
1)Accel superram gaskets are expensive(duty,taxes and shipping) and takes two weeks to ship at the earliest.
2)The Accel gasket holes are barely fit the TPIS bigmouth manifold..
Daz
reasons for going this route:
1)Accel superram gaskets are expensive(duty,taxes and shipping) and takes two weeks to ship at the earliest.
2)The Accel gasket holes are barely fit the TPIS bigmouth manifold..
Daz
#2
Supreme Member
Joined: Jan 2001
Posts: 1,978
Likes: 0
From: PA
Car: 88 Firebird WS6
Engine: 350 TPI
Transmission: T56
Axle/Gears: 3.42
I cut stock gaskets for my siamesed SLP's if I need to raplace them.... I'm sure it would work ok for you... Just use sharp scissors because there's a metal laminate in the center thats pretty tough to cut.
Thread
Thread Starter
Forum
Replies
Last Post
Genopsyde
Engine/Drivetrain/Suspension Parts for Sale
3
10-07-2015 08:35 PM