What tap for bellhousing bolts??
#1
Banned
Thread Starter
iTrader: (1)
Join Date: Feb 2000
Location: Bound Brook, NJ USA
Posts: 1,198
Likes: 0
Received 1 Like
on
1 Post
Car: 89 IROC-Z
Engine: 383
Transmission: 700R4
What tap for bellhousing bolts??
I got my block back from the machine shop yesterday and one of the engine stand bolts won't thread in right. Those are the holes for the bellhousing right?? What size tap do I need to clean them up so I can get the bolt in??
------------------
Riccioli Performance Motorworks
--RPM Racing--
-Currently building first ever engine. 383 with Super Ram plenum and runners, Edelbrock lower intake, Bosch 24# injectors, AFR 190 heads, MSD ignition.
-Will be installing Baer Brakes
-Will be installing full Spohn suspension in rear
-Art Carr 700R4 trans??
Attention Everyone!!! I will be changing my name on the message boards to HardcoreZ28 sometime in the near future. Just wanted to let everyone know.
------------------
Riccioli Performance Motorworks
--RPM Racing--
-Currently building first ever engine. 383 with Super Ram plenum and runners, Edelbrock lower intake, Bosch 24# injectors, AFR 190 heads, MSD ignition.
-Will be installing Baer Brakes
-Will be installing full Spohn suspension in rear
-Art Carr 700R4 trans??
Attention Everyone!!! I will be changing my name on the message boards to HardcoreZ28 sometime in the near future. Just wanted to let everyone know.
#4
SBC = 3/8-16 UNC. Use a bottoming tap instead of a plug tap to clean up all the threads.
------------------
Later,
Vader
------------------
"Fear is how I fall, Confusing what is real..."
Adobe Acrobat Reader
------------------
Later,
Vader
------------------
"Fear is how I fall, Confusing what is real..."
Adobe Acrobat Reader
Thread
Thread Starter
Forum
Replies
Last Post
dimented24x7
Tech / General Engine
4
09-06-2015 03:51 PM