rdog30

I need to have valve seals installed on my heads and was wondering what the cost would be for a shop to do it? Or the time it would take to do it? the car emits blue smoke when you start it,rev the engine it smokes more. Could I have bad piston rings as well?

------------------
85 305tpi Trans am
flowmaster exaust
K&N air filter, 4:11 rear gears

ede

call a shop in your area and ask, i'd say about 3 hours flat rate, but don't know for sure.

------------------
ICON Motorsports

1st & 3rd
MM Black Diamond Lodge 538 F&AM

Ward

iTrader: (1)

Most likely it is your valve seals and guides. Mine does this too, I need to get it fixed. My suggestion would be to go to an engine shop and get a pair of rebuilt heads. They will take yours and give you the core charge for them. The shop I go to is City Motor Supply and their heads are $95 each after core charge. If your heads are cracked or anything and they can't take them then you will have to pay like 30 or 40 dollars more per head.

------------------
1983 Firebird
TH700R4 Auto
Small Block 400
LG4 ECM, Intake, Carb, Distributor, etc.
Soon to be non-computer.
Clarion Head Unit 45X4
2 Pioneer 400W 12" Subs
Third Gen Performance
"A four cylinder is half an engine."