POS steering column
#1
Thread Starter
Member
Joined: Oct 2003
Posts: 296
Likes: 0
From: Houston
Car: 1992 25th Ann. Z28
Engine: 5.7 TPI - Stock
Transmission: th700 r4
Axle/Gears: 3.23
POS steering column
Spent today(day off) to fix what I thought were the 4 bolts in the tilt column to repair the heavy play in steering wheel. Wouldn't you know it.. the POS was completely torn down... only to find the 4 torx bolts ARE ON. Absolutely nothing to tighten in that area.
I took my time and did everything by the write ups found in the forum. Any ideas what the problem is?
The center shaft just moves in and out... I mean a kid could have gave a slight yank and it would move about 1/2 an inch.
PLEASE somebody help. Should I give up and but a used replacement or have somebody look at it?
As many time as I tore this thing apart... I could most likey do tear it down again blind folded.
I summon the Tech Wizards of the TGO web to help find a solution..:hail:
I took my time and did everything by the write ups found in the forum. Any ideas what the problem is?
The center shaft just moves in and out... I mean a kid could have gave a slight yank and it would move about 1/2 an inch.
PLEASE somebody help. Should I give up and but a used replacement or have somebody look at it?
As many time as I tore this thing apart... I could most likey do tear it down again blind folded.
I summon the Tech Wizards of the TGO web to help find a solution..:hail:
#2
TGO Supporter
Joined: Sep 2003
Posts: 6,127
Likes: 8
From: conway, s.c.
Car: 1989 Iroc-Z
Engine: 5.7L TPI
Transmission: 700R4
Am sending you some information by e-mail that might help you some. It is from a 1989 Gm service manual, but the info shoukd be the same.
The Trickster!!!!!!!!!!!!!!!!
The Trickster!!!!!!!!!!!!!!!!
#3
Thread Starter
Member
Joined: Oct 2003
Posts: 296
Likes: 0
From: Houston
Car: 1992 25th Ann. Z28
Engine: 5.7 TPI - Stock
Transmission: th700 r4
Axle/Gears: 3.23
COOL!
Thanks Trickster!!:yourock:
This will help me find the possible weak points of the shaft that is causing the problems.
This will help me find the possible weak points of the shaft that is causing the problems.
#4
Thread Starter
Member
Joined: Oct 2003
Posts: 296
Likes: 0
From: Houston
Car: 1992 25th Ann. Z28
Engine: 5.7 TPI - Stock
Transmission: th700 r4
Axle/Gears: 3.23
"Plastic Injections"??
In the service manual, page 3F2-4 (thanks Trickster) the is a notice that reads -
"Dropping cloumn on its end could collpase steering shaft or loosen plastic injections that keep the column rigid."
Anybody know where these injections are?? Where would the shaft collapse(shafts under hood, or shafts in the column)??
"Dropping cloumn on its end could collpase steering shaft or loosen plastic injections that keep the column rigid."
Anybody know where these injections are?? Where would the shaft collapse(shafts under hood, or shafts in the column)??
Thread
Thread Starter
Forum
Replies
Last Post
sjorgens
Suspension and Chassis
7
10-01-2015 07:54 PM