Creaking noise in rear on corners
#1
Member
Thread Starter
Join Date: Nov 2000
Location: USA:)
Posts: 183
Likes: 0
Received 0 Likes
on
0 Posts
Creaking noise in rear on corners
Sometimes whil making turns,especially left turns,I don not know how to describe it,a loud creak coming out of my left rear,my right side did it once too,I belive it is the suspension,the rear shocks are fairly new,I heard that IROCZ's with the stiff suspension creak with aging,is that what this is??
------------------
86 iroc,canary yellow,fully loaded
------------------
86 iroc,canary yellow,fully loaded
#2
Junior Member
Join Date: Dec 2000
Location: Groton, CT
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
A couple things will more than take care of this:
Subframe connectors
New Springs or shocks
Panhard rod
Hope this helps.
------------------
Dan Young
1995 Z28/M6
Groton, CT
1985 Z28/A4
(Prospective purchase)
Subframe connectors
New Springs or shocks
Panhard rod
Hope this helps.
------------------
Dan Young
1995 Z28/M6
Groton, CT
1985 Z28/A4
(Prospective purchase)
#3
Supreme Member
iTrader: (2)
Join Date: Nov 2000
Location: Ft Worth, TX USA
Posts: 1,188
Likes: 0
Received 2 Likes
on
2 Posts
Car: 2016 Ram 1500
Engine: 3.0L Diesel
Transmission: 8sp
I had a simmilar creak and it was that the spring wasn seated in the frame correctly.
so look at the springs especially if you just changed them and did not replace the isolators.
------------------
88 WS6 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
free mods, dynomax exh, urethane motor+trans mounts,
SSM frame con, Bilsteins
very trick homemade ramair.
so look at the springs especially if you just changed them and did not replace the isolators.
------------------
88 WS6 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
free mods, dynomax exh, urethane motor+trans mounts,
SSM frame con, Bilsteins
very trick homemade ramair.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM