Flow info on the GM LM1 heads
01-01-2003 | 10:49 AM
#1
Thread Starter
Member
Joined: May 2002
Posts: 197
Likes: 0
From: Philadelphia
Flow info on the GM LM1 heads
I was wondering if anyone has any flow info the heads that come on the GM Goodwrench LM1: http://www.sdpc2000.com/cart.asp?act...id=130&pid=383
01-02-2003 | 03:10 PM
#2
Member
Joined: Oct 2001
Posts: 154
Likes: 0
From: southington, ohio usa
I bought that motor about a year ago. I dont have flow #'s for them but the heads looked absolutely TERRIBLE!!! I have never seen ports that goobered up before. thats why they are still sitting in my garage. But, you could probably make some use of them if they were ported and polished.
01-02-2003 | 04:19 PM
#3
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 3
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
theyd be good boat anchors, thats about it. I have 'em on my motor and YUCK, they suck **** bigtime. As for that 249 hp, HA! more like 190 with the cam it has. If you have a set of those heads id take them and melt them down into soup cans. Thats about all their good for is the iron.
Thread
Thread Starter
Forum
Replies
Last Post
Mickeyruder
Engine/Drivetrain/Suspension Parts for Sale
3
09-02-2015 03:45 PM
