Aluminum intake elbow!!!!!
#1
Supreme Member
Thread Starter
Aluminum intake elbow!!!!!
I just got my summit racing cataloge a few days ago, and just got around to looking in it, and under the new TPI\LT1\LS1 section, i see that Vortech has made a new Intake Elbow for 93-97 LT1's.. Its aluminum with ruber connectors.. I searched for them online, and couldn' find anythiing, and summit didn't have a pics of them, So if u have a summitracing cataloge you will have to look on the last pages for it. Or i will try and scan it. But anyways, this is my question, what are the differences in the intake elbow on a LT1 and a TPI? (assuming its on a Trans Am)... because i would love to get this, it seems to be alot higher quality then the stock piece.. its part # vor-4gh112-050 for summit
#3
Supreme Member
Join Date: Jan 2001
Location: PA
Posts: 1,978
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 Firebird WS6
Engine: 350 TPI
Transmission: T56
Axle/Gears: 3.42
It appears that it is not long enough 'before the bend' for out TPI cars. It would prolly run real close if not hit the A/C compressor.
#4
Supreme Member
Thread Starter
perhaps you are right. But i was thinking that too, but then i started wondering if maybe the rubber connector would give it the length it needed to clear everything ok.. Maybe we should all ask Vortech to make one for TPI..
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
1
11-19-2015 07:03 AM
86CamaroDan
Engine/Drivetrain/Suspension Parts for Sale
2
09-29-2015 10:08 PM