TBI Adapter bolt interference?
#1
TGO Supporter
Thread Starter
Join Date: Oct 2000
Location: Wilmington NC
Posts: 1,231
Likes: 0
Received 0 Likes
on
0 Posts
Car: C1500
Engine: 350
Transmission: 700r4
Axle/Gears: 2.73
TBI Adapter bolt interference?
I am swapping intakes. I got the Edelbrock 2104 and a Transdapt TBI adapter plate. I was mocking it up tonight when I realized what may be a big problem. Two of the three throttle body bolt holes are blocked by the edge of the intake.
Could I just use washers to space the bolts so that they don't threat all the way through the plate?
Could I just use washers to space the bolts so that they don't threat all the way through the plate?
#4
Re: TBI Adapter bolt interference?
Those factory 454 adaptors are restrictive, plus they rob hood clearence.
Yeah, make studs or assemble the tbi to the adaptor (w/ gasket), & shave the remaining bolt that is sticking out of the bottom.
Yeah, make studs or assemble the tbi to the adaptor (w/ gasket), & shave the remaining bolt that is sticking out of the bottom.
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Tech / General Engine
22
01-09-2020 08:29 PM