RBob

iTrader: (1)

I haven't dealt with an ADS file for years. So I don't know how changes are made.

RBob.

Armored91Camaro

I changed the areas you said to change, i havent started the car yet as its late here 11:30pm , but i did notice that when the key is turned to the on position the check engine light flashes constantly instead of staying solid like it usually does. Ill crank it in the morning before i goto work, worse thing that can happen is limp mode i think.

RBob

iTrader: (1)

The fast flashing CEL is limp mode. Likely didn't get the checksum to update with the BIN changes.

RBob.

Armored91Camaro

hmm, that is possible. I used a new .bin file and changed those perameters first then changed everything else i wanted. I cant rememeber if i saved imediately after changing the parameters for SA to be shown.
The car did startup and run but check engine continued flashing. So i resorted back to my other chip.
I will start over with another new .bin file and see what happens. It will be atleast another 10 hours before i can do anything though.