acceptable - Third Generation F-Body Message Boards

Thread / Thread Starter

Last Post

Replies

Views

Forum

350, acceptable, l05, play, stem, valve, valves

play allowed on valve stem inside the guides ? 350 L05

Jabpir8 on 03-25-2013

03-26-2013 10:29 AM
by 1986Z28OWNER

9

3,136

Tech / General Engine

1986, 700r4, 87, acceptable, camaro, contact, gear, pattern, patterns, reverse, ring, runout, seized, trans, transmission, zf6

Is this gear pattern acceptable?

1983Zsled on 05-29-2012

06-03-2012 07:43 PM
by TTOP350

22

12,677

Transmissions and Drivetrain

2012, 92, acceptable, camaro, count, counts, ecm, gen, knock, powered, tpi, track, valley, vbulletin, walk

knock counts ...

freaky on 02-29-2012

03-01-2012 09:42 AM
by freaky

6

1,172

DFI and ECM

acceptable, bew, fuel, gasket, gm, injection, injector, injectors, leak, leakdown, oil, pan, pressure, specification, time

Fuel Injector Leakdown Time?

Dark Ember on 01-25-2012

01-25-2012 06:50 AM
by ex-x-fire

1

763

Tech / General Engine

1987, 82, 86, acceptable, amp, camaro, car, cords, current, disconnected, draw, ed, hook, negative, parasitice, power, turn

Are Thirdgens Supposed to Draw a Small Amount of Power, Even When Turned Off??

johnjm22 on 05-28-2011

05-31-2011 12:34 AM
by Six_Shooter

12

1,289

Electronics

acceptable, adjust, adjusting, af, afr, afrthirdgen, lean, open, pro, rt, throttle, timing, tuner, tunerprothirdgen, wide, wot

need help with adjusting AFR at WOT

91Camaro_RS on 04-27-2011

04-28-2011 08:53 AM
by bjankuski

1

1,273

DIY PROM

88, acceptable, camaro, clearance, clearence, end, front, grinding, outer, rod, rubbing, rubs, tie, toe, wheel, wheels, zr1

Wheel to tie rod clearance problem

dust3r on 04-17-2010

07-30-2010 08:57 AM
by Stephen

15

13,953

Suspension and Chassis

400, 93, acceptable, camaro, clearance, dome, formula, l2304, minimum, piston, pistons, safe, trans, trw, valve

pistons to valve clearance

greatskiiiier on 02-15-2010

02-18-2010 01:07 PM
by Sonix

47

7,519

Tech / General Engine

1991, 350, acceptable, bbc, body, chevy, install, normal, oil, pressure, sensor, t400, temp, temperature, transmission, z28

Acceptable Oil Temperature

nascarfan7 on 10-09-2009

12-25-2009 07:39 PM
by AlkyIROC

4

1,933

Tech / General Engine

acceptable, check, checking, guide, guides, knurl, knurling, movement, play, ply, sbc, side, slop, valve, valves, worn

max. side to side play for valve guides?

wanab03ss on 03-25-2009

03-26-2009 06:02 AM
by Atilla the Fun

5

5,590

TPI

acceptable, code, elbow, engine, fuel, gm, l79, oil, pressure, pump, run, sbc, sensor, sjc, tpi

old gen sbc in tpi(oil sender issue)

Toyota h8r on 02-17-2009

02-18-2009 02:58 AM
by Apeiron

10

1,238

TPI

acceptable, cam, camshaft, check, comshaft, gear, ll8, run, runout, signs

Camshaft runout

irocnroll89 on 02-08-2009

02-09-2009 06:29 AM
by 86LG4Bird

3

1,298

Tech / General Engine

acceptable, adjusting, adjustment, bell, bellhousing, check, checking, flywheel, gen, housing, offset, run, runout, tool, vehicle

OK how many of you actually check bell housing runout?

antman89iroc on 12-26-2008

12-31-2008 06:41 AM
by antman89iroc

4

889

Transmissions and Drivetrain

Engine Fumes from Shifter Hole?

Kevin84Z28 on 10-31-2008

11-04-2008 06:35 PM
by Kevin84Z28

8

1,249

Transmissions and Drivetrain

305, 454, 88, 99, acceptable, body, cable, camaro, play, shaft, sticking, sticks, tbi, throttle

Throttle sticks but isn't pysically sticking

PyRo9862 on 12-29-2007

02-18-2008 01:30 PM
by oldred95

7

2,182

TBI

350, 9, acceptable, axle, backlash, drive, ford, gear, inch, pattern, patterns, pictures, proper, ring, tooth

Help With Ring Gear Tooth Pattern (Ford 9")

Procharged GTA on 01-24-2008

01-25-2008 05:56 PM
by hwcoll95

2

1,436

Transmissions and Drivetrain

1987, acceptable, allowed, axle, camaro, cost, distributer, distributor, distrubtor, have, indistributor, play, prizm, rotor, shaft, side, tolerance

How much distributor play is ok? Accel Dual sync

388 on 06-24-2007

06-25-2007 01:48 AM
by bodie

1

3,013

DFI and ECM

Acceptable oil PSI?

The_Wraith on 06-12-2007

06-12-2007 04:28 PM
by Apeiron

1

443

Tech / General Engine

006, 2032, 99, acceptable, at, cherokee, contact, crane, depth, gramd, ivcp, jeep, pattern, pinion, ring, set

trying to setup my rear gears

86Z on 10-07-2006

10-10-2006 10:59 AM
by 86Z

9

770

Transmissions and Drivetrain

350, acceptable, chain, chainis, check, correct, engine, excessive, gear, ls, ls1, much, play, slop, timig, timing

Timing chain play...

89RsPower! on 10-01-2006

10-01-2006 04:35 PM
by ede

3

2,200

Tech / General Engine

111, 383, acceptable, audio, cam, idle, lopy, roller, solid, squirters, stroker, vibrating, vibration, xr294hr

383 Stroker

zrated57 on 03-30-2006

04-02-2006 01:38 PM
by Dialed_In

10

1,763

Tech / General Engine

Piston Slap

MadOTC on 03-20-2006

03-22-2006 08:53 AM
by Vader

1

702

Tech / General Engine

43l, acceptable, cold, cylinder, down, engine, hot, kit, leak, leakdown, procedure, sbc, test, tests, vs

Cylinder leakdown testing...Hot or Not?

Confuzed1 on 09-14-2004

08-02-2005 06:45 PM
by 87350IROC

33

2,355

Tech / General Engine

acceptable, b18c, bearing, block, bore, boring, engine, engines, flywheel, line, main, race, sbc, tolerance, tolerances

Proper Line Bore Tolerances??

Paul Riccioli Jr on 07-01-2004

07-01-2004 02:07 PM
by Paul Riccioli Jr

4

1,297

Tech / General Engine

acceptable, camaro, coolant, cooling, drop, engine, leak, loses, losing, pressure, pressurizing, radiator, system, test, tester

losing pressure in cooling system

Nebu on 05-20-2004

05-20-2004 01:45 PM
by kevinc

6

1,046

Tech / General Engine

1416, 2900, 50000, acceptable, camaro, code, count, counts, engine, high, knock, read, sensor, tbi, trouble

high knock counts

ssxmac on 05-01-2004

05-03-2004 07:51 PM
by ssxmac

8

3,027

TBI

acceptable, engine, good, hg, manifold, performance, reading, vacuum, whats

What's Acceptable Vacuum?

camaronewbie on 04-17-2004

04-19-2004 12:38 PM
by RB83L69

4

783

Tech / General Engine

acceptable, drop, fuel, injection, pressure

Fuel pressure drop/ What is acceptable?

Ken Ruether on 11-06-2003

11-06-2003 09:54 PM
by Ken Ruether

5

753

TPI

10206039, acceptable, chain, crank, gear, gm, loose, lt1, oversized, parts, pn, set, slack, sprocket, timing

LT1 timing set ???

_max_ on 10-20-2003

10-22-2003 04:35 PM
by Vader

4

2,843

Tech / General Engine

19, 1999, 97, acceptable, acceptble, cam, cams, camshaft, litre, lobe, lobes, polish, roller, saturn, wear

how much cam lobe wear is acceptable?

tpivette89 on 09-25-2003

09-26-2003 06:10 AM
by SMasterson

6

5,824

Tech / General Engine

acceptable, glue, goo, inside, insie, loose, magnet, magnetic, magnets, pa, pan, peice, silver, th400, transmission

Magnet inside the transmission pan

25THRSS on 08-15-2003

08-19-2003 02:19 AM
by Pro Built Automatics

4

1,670

Transmissions and Drivetrain

400, acceptable, classic, cylinder, down, engibe, engine, leak, leakdown, motor, pontiac, sr20det, stand, test, transmission

can a leakdown test be done on on engine stand

BOTTLEDZ28 on 07-30-2003

08-01-2003 02:13 PM
by ploegi

7

3,721

Tech / General Engine

89, acceptable, accptable, amount, camaro, car, clutch, engine, exceptable, excessive, fly, flywheel, jutter, run, runout, wheel

How much flywheel run-out is acceptable?

Andy Fanshawe on 05-27-2003

05-27-2003 04:26 PM
by Andy Fanshawe

0

781

Transmissions and Drivetrain

acceptable, black, crank, crankshaft, dark, emery, journal, journals, mower, polish, ridge, scuff, scuffed, spot, turning

scuffed crank journals

1991tealRSt-topGuy on 10-10-2002

10-12-2002 06:14 PM
by 1991tealRSt-topGuy

21

907

Tech / General Engine

acceleration, acceptable, count, counts, good, knock, l98, whats

What's an "acceptable" knock count?

Jza on 08-05-2001

08-06-2001 12:07 AM
by Rallyssport

4

754

Tech / General Engine

1985, acceptable, axle, backlash, camaro, check, checking, gear, gm, ring, tolerance, tolerances, tolerence

Quick!! What is the backlash tolerance for GM gears?

Omega on 03-12-2001

03-12-2001 07:56 PM
by OLDYELLR

1

755

Transmissions and Drivetrain

Threads Tagged with acceptable