founder performance lcarbs
#1
Thread Starter
Supreme Member
iTrader: (9)
Joined: Mar 2007
Posts: 1,804
Likes: 2
From: Raleigh, NC
Car: 1988 Flame Red Trans am GTA
Engine: Forged 355 4 Bolt, FIRST TPI
Transmission: 700r4
Axle/Gears: ls1 torsen 3.42 gear
founder performance lcarbs
what do you guys think of these
http://www.foundersperformance.com/p...-Brackets.html
i need a set and i came across these... should i get them... bmr and others want around 80 plus for their bolt on set.......
http://www.foundersperformance.com/p...-Brackets.html
i need a set and i came across these... should i get them... bmr and others want around 80 plus for their bolt on set.......
#2
Joined: Aug 2006
Posts: 12,667
Likes: 50
From: Central NJ
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: founder performance lcarbs
i have a set, cant beat the price, and they come with new bolts. The seem well made, and the coating was nice.
i see they have rip-off hotpart strut mounts now too, a good price as well.
i see they have rip-off hotpart strut mounts now too, a good price as well.
#3
Thread Starter
Supreme Member
iTrader: (9)
Joined: Mar 2007
Posts: 1,804
Likes: 2
From: Raleigh, NC
Car: 1988 Flame Red Trans am GTA
Engine: Forged 355 4 Bolt, FIRST TPI
Transmission: 700r4
Axle/Gears: ls1 torsen 3.42 gear
Re: founder performance lcarbs
thanks man i need these badly because i lowered my car and handling suffered a little.handled like it was on rails before... but i expected to suffer abit.. i just bought a adjustable panhard bar and now im getting these brackets.... i looked and my control is not level anymore... the rear end side is abit higher than the chassis side now.... so i need them... then im going to get new front tires and alignment and see where that takes me...... basically i have full aftermarket suspension now...
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
05-17-2020 11:44 AM