Question on installing Hotpart/J&M strut mounts...
#1
Supreme Member
Thread Starter
iTrader: (5)
Join Date: Aug 2007
Location: Milwaukee, Wisconsin
Posts: 1,525
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 IROC-Z
Engine: 383 with Edelbrock ProFlow EFI
Transmission: TH350
Axle/Gears: 12 bolt 3.73 Eaton posi
Question on installing Hotpart/J&M strut mounts...
I just received the package on Tuesday and wow do they look nice. After a little panic about not receiving the bearings, I found them wrapped up in the paper used as cushion... good thing my dad told me to keep it together until I have time to install it instead of throwing the packaging away. Any way, the bushings have a flat spot on one side and they are curved on the other. Does it matter which way they go in? I was sliding them around when they were in there and they seem to fit both ways.
Mike
My Koni Yellows and Eibach Pro-kit springs were just dropped off a half hour ago. I can't wait to get them on the car... it's killing me!
Mike
My Koni Yellows and Eibach Pro-kit springs were just dropped off a half hour ago. I can't wait to get them on the car... it's killing me!
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Suspension and Chassis
1
08-09-2015 04:32 PM