Cut the bull, Time to go racing.......
#52
Supreme Member
iTrader: (3)
Re: Cut the bull, Time to go racing.......
One more thing Jon. When your car was on the dyno you could hear the exhaust struggling to exit. A couple of people commented on it including the dyno owner. So yes, I bet you picked up a good amount of power and that was reflected in your mph.
#53
Member
Join Date: Sep 2000
Location: SoCal
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Car: '91 Camaro Z-28
Engine: 350
Transmission: auto
Re: Cut the bull, Time to go racing.......
1989GTATransAm Hmmmm, we need to figure out why you are not getting good traction. Maybe front brake line lock for a decent burnout?
The tires are few years old so maybe they're not as good as they once were?
Then again my posi has nearly 140,xxx miles on it so maybe it is giving up a tad?
It always leaves two stripes on the street but maybe the stickier tires are too much for it to handle. Should my suspension/tire combination be able to easily provide traction for the amount of power the motor is putting out?
Last edited by slow91camaro; 04-10-2010 at 11:08 AM. Reason: grammar
#54
Supreme Member
iTrader: (3)
Re: Cut the bull, Time to go racing.......
"Then again my posi has nearly 140,xxx miles on it so maybe it is giving up a tad?"
Don can put your car on the rack and check the pose pretty quick. Mine failed the test and had to be fixed. I gave him a punch of posi-shims that were ordered for my car. We just need to get you squared away for the Invasion. I think a bunch of us are going to show the 4th Gens how it is done at the track.
Don can put your car on the rack and check the pose pretty quick. Mine failed the test and had to be fixed. I gave him a punch of posi-shims that were ordered for my car. We just need to get you squared away for the Invasion. I think a bunch of us are going to show the 4th Gens how it is done at the track.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM
TA8487
Engine/Drivetrain/Suspension Parts for Sale
0
08-11-2015 09:02 PM