Hey guys

i finally found my 6 speed and
decided it needs to be in my car next week LOL

all the parts will be here nxt week

i will be sellingmy t5 setup complete

Also we need to start ALL going to the 91st and northern on fri

and we my camaro crew found a house full of imports to race on sat or fri night so

bring your whips out to 91st and northern and i will start taking pics and what not ....

 

Cool!! I'm gonna try to make it out next week too. There are a couple of things I need to do to my IROC by then but I think I will make it. Hope to see you guys there

 

LOL, I just found another t-56 today and bought it on the spot!! LOL, looks like I wont have to use the t-56 from my RS after all, YAY! I will find out about the centerforce for you this weekend....

 

i said f it and bought the flywheel and clutch centerforce 1000 HOORAY!!!!!
lol

how much did you get your 6 speed for ?>???

 

I ripped off my TPI setup and put it back on

sooo much fun let me tell you

love the practice

Can everyone please cross your fingers that my intake seals right this time!!!!!!

ANd

Cross your fingers that my rear main seal is ok too !!

cause if its leaking i am pulling my motor b4 that pretty 6 speed goes in!!!

 

I got mine for 700. It came out of a 95 T/A w/ 31,000 miles. Its been sitting for over 10 years and I'm hoping its all right. Going to rebuild it anyways...
I would change the rear main anyways, when you swap the trans. I still need a clutch and hyd and 4thgen pedals....

 

I have a set of pedals out of a 96 T/A M6 car.

 

How much? Take 50? LMK. Thanks!

 

Plus the ride?

 

Where are you located? I travel all over for work, so I might be able to pick them up...

 

Located in Kingman.

 

I go to seligman and peach springs around once or twice a week (Just east of kingman). Maybe we could arrange a meet?

 

PM sent.

 

HOrray i got the 6 in the car and everything else pedals ,

hydraulics, etc, what fun !!!

now all i am waiting for is a stupid bracket...

i am going to get it shippped from another chevy in the country...

soon it will be going..

 

Yay! Any chance you will have it working on friday?

 

Yes the bracket is discontinued and is only at like 5 more chevy spots in the country jason so you better order that shiz soon. I got it overnighted to me cod and it cost 88$

the part list for 50 from chevy..
i have the list already of who still has it..

yes tomorrow all i need to do is tighten my motor mounts..
pop the clutch fork over the throwout bearing and install the slave.
I still need to get a vss sensor hookup and hookup the dakota digital box up so that the computer sees the vss

and i need to drop my distributer and hookup wires and time it..

And hookup the starter <--hopefully mine fits or i will buy one...

Then 350-400 miles of 50% throttle.. HORROAY
I need to have it broke in and at least one nights worth or racing on the trans before nov 29 because my warranty is till then

Everything is looking good.. little worried about 6th gear but hope its all good.

I think i am going to go with a 4th gen console and dash......

assuming nothing terribly goes wrong then yes it will be up there fri....!!!
LETS GET A CREW UP THERE THIS FRI
I WILL GET LIKE 6-10 camaros and firebirds so jason show up

and master distaster and iroc fast and arizona iroc all needf to roll up there!!!
get up there around 7:30 8ish

 

well on the plus side i just installed my poly suspension, on the bad side i work fridays til 10 lol if i had the day off id definitely be there

 

Ok, I found some;
www.gmpartshouse.com
They only have like a hundred of them, so If you need one, get it now!

Part lists for 36.00 and shipping is 8.50
I bought two!
LOL