sfeeney

iTrader: (1)

I figured i would post here before i put stuff on ebay or craigslist again..

I have two motors

one 350 .60 over with flat top pistons double roller timing chain, mild to moderate cam. long block with heads pretty fresh less than 2000 miles..
complete with access like alternator, ps pump, etc distrib wires
asking 550 obo

one 305 roller cam/lifters comes with access but no distrib
asking 475 obo

700 r4 tranny asking 225 obo

Near mint complete front and back carpet 100 obo
allot of black interior plastics obo
complete set of red plastics obo
complete set of red seats, black seats, grey rear seats, obo

complete iroc ws6 suspension setup 150
84 teardrop hood 70 obo
86 iroc hood no louvers small dent 20 obo
White, red and maroon back glass hatchs 20 each

complete tpi setup including computer, prom, wiring harness for tpi and under dash wiring with fuseblock, distrib with wires cap and rotor, coil with mounting bracket. all sensors, intake plenum runner fuel rail with new regulator, injectors, etc. every bolt and nut that came off. relays and esc and brackets its pretty much super complete
350$

front nose will be available , gfx, doors,

complete black seatbelt set 60$obo
complete red seatbelt set 35$obo

red headliner that i can make any color you need with correct fabric paint..

TonyC

iTrader: (1)

Any more details on the 350? Casting number on the heads? What did it come out of? Built by? How's the compression on it?

sfeeney

iTrader: (1)

It is 350 with casting number 3970010 and the heads are 350 194 heads..

The engine was built by a company in yuma. i dont know the name

It has less than 2000 miiles on it , it came out of 86 camaro but was not original motor.

more than likey it is a 4 bolt main, has flat top pistons and double roller timing
and a mild to moderate cam. We pulled this from a parts car we bought. has tons of power..

assuming its around 10 to 1 havent tested though

doesnt smoke runs strong includes a bunch of access and such

TonyC

iTrader: (1)

Is it a 2 piece rear main seal motor? Are the heads centerbolt or perimeter? I'll let you know in a bit, just gotta check the budget for the month

sfeeney

iTrader: (1)

it should be 2 piece and the heads are perimeter..

i have an edelbrock performer rpm intake and cast aluminum valve covers that we can work into the deal if you need them
i also have carb and tpi setups

sfeeney

iTrader: (1)

i have a video of the motor running in the car it came from so if your interested you can see that.
i cant send it because it is 100 mbs.
it had great oil pressure which i also have a video to prove..
let me know

AZKING

350 FOR THE TPI SET UP GET AHOLD OF ME IM INTERESTED

sfeeney

iTrader: (1)

az king i pmed youi

there is another party interested in that so let me know if you want that...