Looking for a fellow Camaro entusiast to help me with RUST
#1
Supreme Member
Thread Starter
iTrader: (10)
Join Date: Oct 2007
Location: Fl.
Posts: 1,881
Likes: 0
Received 2 Likes
on
2 Posts
Car: 83 Trans Am / 96 Jeep XJ
Engine: 355 / 4.0 I6
Transmission: TH350 / Auto
Axle/Gears: 3.23 10-bolt / 4wd
Looking for a fellow Camaro entusiast to help me with RUST
Tampa, Florida
I recently acquired an 88 IROC Convertible, and despite its current condition, I love it. In order to keep this car alive, and restore it back to its original glory, I need the floor fixed first.
Im not looking for a handout, just a fellow camaro enthusiast to help me out. I dont have much cash at the moment, but I have a variety of 3rd gen parts I can offer up for some help.
Here it is, I know its not as bad as I have seen it, but it cannot be ignored.
Thanks,
Bradley.
I recently acquired an 88 IROC Convertible, and despite its current condition, I love it. In order to keep this car alive, and restore it back to its original glory, I need the floor fixed first.
Im not looking for a handout, just a fellow camaro enthusiast to help me out. I dont have much cash at the moment, but I have a variety of 3rd gen parts I can offer up for some help.
Here it is, I know its not as bad as I have seen it, but it cannot be ignored.
Thanks,
Bradley.
Last edited by bradley23150; 08-08-2009 at 10:01 PM. Reason: Added location
#3
Member
iTrader: (5)
Join Date: Dec 2007
Location: iowa
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Iroc Camaro
Engine: Stock 350 TPI
Transmission: 700r4
Re: Looking for a fellow Camaro entusiast to help me with RUST
i wish i lived closer i love to save third gens. Just keep at it don't give up.
#4
Supreme Member
iTrader: (30)
Join Date: Jul 2000
Location: Fort Myers, FL
Posts: 1,516
Received 17 Likes
on
10 Posts
Car: 91 Firebird
Engine: 6.0
Transmission: T56
Axle/Gears: 3.73
Re: Looking for a fellow Camaro entusiast to help me with RUST
Wow, thats really bad
I've been debating parting out my 88 'vert. Its floorboards are solid and it has two sets of aftermarket sfc's installed....... hrmmmmm
could be cheaper than piece mealing yours back together.....
-jason
I've been debating parting out my 88 'vert. Its floorboards are solid and it has two sets of aftermarket sfc's installed....... hrmmmmm
could be cheaper than piece mealing yours back together.....
-jason
#5
Supreme Member
Thread Starter
iTrader: (10)
Join Date: Oct 2007
Location: Fl.
Posts: 1,881
Likes: 0
Received 2 Likes
on
2 Posts
Car: 83 Trans Am / 96 Jeep XJ
Engine: 355 / 4.0 I6
Transmission: TH350 / Auto
Axle/Gears: 3.23 10-bolt / 4wd
Re: Looking for a fellow Camaro entusiast to help me with RUST
And, I found out yesterday that my neighbor welds for a living, so Im going to cut the floors out of one of my parts cars, and have him weld em in.
Thanks guys!
Thread
Thread Starter
Forum
Replies
Last Post