Making a car poster
08-14-2012, 11:53 AM
#1
Making a car poster
Since I finally had the ZR1 rims installed on my GTA I decided it was time to make the poster.
No text on it yet so this is a proof. Also, once my GTA is mobile again and not dead in the water with a busted engine I'll clean it up and take a new photo without the license plate on the car.
Full resolution is a 24x36" poster designed to be printed on 3mm waterproof PVC, or on Acrylic for a "gloss" look.
This is a "thumbnail" at 800x1200.
No text on it yet so this is a proof. Also, once my GTA is mobile again and not dead in the water with a busted engine I'll clean it up and take a new photo without the license plate on the car.
Full resolution is a 24x36" poster designed to be printed on 3mm waterproof PVC, or on Acrylic for a "gloss" look.
This is a "thumbnail" at 800x1200.
08-14-2012, 12:16 PM
#2
Supreme Member
iTrader: (5)
Join Date: Mar 2011
Location: Central Texas
Posts: 2,893
Likes: 0
Received 4 Likes
on
4 Posts
Car: GTA
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: Aussie 9-bolt/3.27 posi
Re: Making a car poster
IMHO......Replace the big car pic with one without the front license plate to match all the small pics of it.
08-14-2012, 02:14 PM
#3
Re: Making a car poster
that pic was the only one I had with a high enough resolution to be printed. I could spend time and simply chop it out and recreate the nose without a plate, but I don't really like the lighting in that picture so i'll just have to wait until I get the LT1 going with the heads/cam/etc...
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
40
08-21-2015 02:12 PM
