Door panel top trim speed nuts
#2
On Probation
Re: Door panel top trim speed nuts
On my 84 the washers were slipped over the plastic studs and then the plastic stud ends are melted down to secure them and hold the door panel and top trim together as one piece. Both doors are done this way and appear to be factory.
#3
Supreme Member
iTrader: (58)
Re: Door panel top trim speed nuts
GM considers the panel and trim as one piece. The nuts don't have a part number in the door panel diagram. Auveco most likely carries something close if not the exact piece. My personal preference would be to obtain them from a donor car.
Choose wisely. Measure originals, pay attention to finish, you don't want the ones with sealer, etc...
Choose wisely. Measure originals, pay attention to finish, you don't want the ones with sealer, etc...
#5
Re: Door panel top trim speed nuts
That's all they are you just flip them over and use a allen bit with a hole inside it. Snap-On part #'s S9614 is 5/16" and S6103 is 3/8". They are pricey!
JOE
JOE
Thread
Thread Starter
Forum
Replies
Last Post