[Sold] PSI LS3/T56 Harness LSX Conversion Swap
#1
PSI LS3/T56 Harness LSX Conversion Swap
'08 - '14 LS3 (6.2L) STANDALONE WIRING HARNESS W/T56/TR6060 Uses E38 ECM, CORVETTE PEDAL, LS3 MAF
Part# HAR-1037Had this Harness on my thirdgen camaro for a few months, kept having an intermittent dead pedal issue that I couldn't track down. Decided I would swap the harness after trying a few other things. Needless to say its not the harness, my car still has the same problem. With that being said I don't need 2 harnesses. These are $569 new. This is in new condition and comes with the wiring diagram paperwork and lists needed parts. Only modification I did was to the coolant sensor connector. I changed from a 2 wire to three wire to operate the stock GM gauge. I still have the two wire that can be spliced back in. This is long enough to route through the fender opening and back into the stock ECM location. $400 shipped.
Part# HAR-1037Had this Harness on my thirdgen camaro for a few months, kept having an intermittent dead pedal issue that I couldn't track down. Decided I would swap the harness after trying a few other things. Needless to say its not the harness, my car still has the same problem. With that being said I don't need 2 harnesses. These are $569 new. This is in new condition and comes with the wiring diagram paperwork and lists needed parts. Only modification I did was to the coolant sensor connector. I changed from a 2 wire to three wire to operate the stock GM gauge. I still have the two wire that can be spliced back in. This is long enough to route through the fender opening and back into the stock ECM location. $400 shipped.
Last edited by jtmiller92; 03-14-2018 at 02:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM
Slow94Formula
Engine/Drivetrain/Suspension Parts for Sale
2
12-31-2011 12:43 AM