'91/'92 highrise Z28 spoiler mod, *Finished, See Post #121!*
#151
Supreme Member
iTrader: (15)
Re: '91/'92 highrise Z28 spoiler mod, *Finished, See Post #121!*
So I'm working on putting the spoiler on my Camaro. I'm taking a slightly different approach than you with the sides and making the fenders taller. I was wondering if you used all four pairs of the spoiler's mounting studs or did you remove the outers and only use the inside pairs?
#152
Supreme Member
iTrader: (15)
Re: '91/'92 highrise Z28 spoiler mod, *Finished, See Post #121!*
The OP seems have left the thirdgen community. Thought I'd post pictures of my finished product. I took the high rise spoiler mod a step further and actually raised and refinished the top of the rear fenders, raised the front of the rear fenders (portion by the back of the door) and then extended down the side pillars of the spoiler. It's a big undertaking, I don't advise you do this unless you are a competent welder and body experience. I also wouldn't even think about asking a body shop to do this as the bill would be enormous.
#153
Supreme Member
iTrader: (15)
Re: '91/'92 highrise Z28 spoiler mod, *Finished, See Post #121!*
When you remove the urethane wrap around spoiler pieces you'll see why they wanted to cover it up with a simple cap...
The last picture shows the height difference between the top of the fenders and the trunk lid is measured at 1/4" WITHOUT the weatherstripping. With the weatherstripping it goes up to 3/8 - 1/2". The water channel also has a big and uneven gap.
The last picture shows the height difference between the top of the fenders and the trunk lid is measured at 1/4" WITHOUT the weatherstripping. With the weatherstripping it goes up to 3/8 - 1/2". The water channel also has a big and uneven gap.
#155
Supreme Member
iTrader: (15)
Re: '91/'92 highrise Z28 spoiler mod, *Finished, See Post #121!*
Rough sanding the first batch of filler
You can see how the front of the fender had to be raised and a new cap created since the urethane piece capped it before. The tonneau cover isn't latched in the picture
#159
Junior Member
Join Date: Apr 2010
Location: Ramsey, MN
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z28 Convertible
Engine: 5.0 V8
Transmission: auto
Re: '91/'92 highrise Z28 spoiler mod, started fiberglass 3/5/11
Do the bolt holes line up at all when going from the factory spoiler to the wing?
Thread
Thread Starter
Forum
Replies
Last Post