B&M megashifter mounted to firebird console?
#1
B&M megashifter mounted to firebird console?
Hey guys, this is the last little P.I.T.A I have to deal with involving my floor pan repair and interior swap, I decided to replace the Camaro center console that the P.O put in my car with the correct Trans Am center console. One thing I forgot was that the B&M megashifter plate was not meant to be mounted to these center plates. has anyone done this? is there any alternatives instead of using the plate B&M provides? I do a lot of metal work for my job so I'm sure I could fab something up but I barely have enough time to work on this car as it is. thanks
the plate comes very close to either blocking the ashtray switch or covering the power mirror cutout. I'd like to retain both if possible.
the plate comes very close to either blocking the ashtray switch or covering the power mirror cutout. I'd like to retain both if possible.
#3
Supreme Member
iTrader: (11)
Join Date: Aug 2013
Location: MICHIGAN
Posts: 4,669
Received 812 Likes
on
617 Posts
Car: 1988 Trans Am
Engine: L03
Transmission: 700R4
Axle/Gears: 10 Bolt 2.73 Open
Re: B&M megashifter mounted to firebird console?
Always wondered how I might approach this myself. Thanks for the photos.
#7
Junior Member
Join Date: Sep 2016
Location: Terre Haute, Indiana
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Pontiac Trans Am GTA
Engine: 388 Stroker
Transmission: 700r4
Axle/Gears: 3:73
Re: B&M megashifter mounted to firebird console?
That looks pretty damn slick mam. Nice work
Thread
Thread Starter
Forum
Replies
Last Post
beths91camaro
Interior Parts for Sale
1
08-17-2016 11:23 AM