When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
I've never felt like such an idiot before, but, I recently began working on a 1982 Z28 with a 350 in it. Hasn't been cranked in years, so I started doing simple stuff, IE cleaning the plugs, putting oil into the cylinders, etc. However, when I went to go take the last two plugs closest to the firewall on the passenger side.. they were barely even hand tight, and I couldn't figure out why. I cleaned them up, went to go put them back in.. can't fit a socket into the tiny gap I have there. Is there any way to get around it other than either A: Taking off the header, or B: Getting header plugs??
I just use the header plugs, I don't drive the car enough to really need to change em often, so it was worth the little bit of extra money for me. As it is even with header plugs, I have to get under the car to reach the back 2 passenger side plugs. Not sure what headers I have but they are a PITA to get to the plugs.
I have a regular/short 5/8", half inch drive socket that I ground 4 flat spots on. The socket slips over the plug, the end sticks out the back, and an open end/crescent wrench can grab onto the flat spots. ...only need this for ONE plug with my RHS heads and SLP headers. ...if I remember correctly, with stock heads, I used it on a few.
Thanx
That is what I use on the SLP headers with stock and angle plug aluminum heads. I built this in the early 90s.
I bought 2 cheap boxend wrenchesm cut off one of the boxed ends and welded it to the other being careful to keep them lined up. Then I ground down the lower boxed end so it'll fit down in the heads.
Everybody has some sort of modified tool to work around aftermarket headers. With the SBC, you're lucky. Although it looks tight, you still have lots of room.
My BBC has 2-1/4" primary tools. I use a combination of tools to check the spark plugs. Most of them I can get a spark plug socket onto then use a wrench on the end of the socket. There's no room for an extension and/or ratchet. Even then, there's not a lot of room to spin the plugs in and out with the socket. Socket is only used to loosen and tighten the plugs. I use a rubber hose type tool that slips over the end of the spark plug and allows me to spin the plug.
The hardest plug is #4. Second one back on the passenger side. My header tubes are all separate and all slide into a collector. The headers go on like a jigsaw puzzle. To get #4 plug out, I need to take out the bolts for the #2 header tube so it flops around and loosen off the #4 header tube. That gives me enough room to access the spark plug.
Yep making a homemade tool is about the best route to go.
I have a few made up for headers. I have a spark plug socket I cut a U out of, sort of like an O2 sensor socket. Then use a wrench on the end of the hex part of socket.
I have a cut and a bent 5/8" open end and box end wrench.
The pass through socket set like "Midias" posted