photoShop request (ZL1 hood)
#3
Supreme Member
![](https://www.thirdgen.org/forums/images/ranks/tgo10.gif)
Re: photoShop request (ZL1 hood)
Couple minutes of fiddling around... finally figuring out this photoshop thing. My opinion is I don't think it'll be the best look without lots of fabrication, at which point you won't have much of a fifthgen hood left. The one hood I've seen that really works on these cars is the Jongbloed/Sunoco hood that follows the existing creases in the stock hood. You could do that and integrate extractors into it similar to the build by user: morrow. Or just put a black vinyl stripe on it.
![](https://www.thirdgen.org/forums/attachments/signature-pictures-photoshop-requests/304765d1468999024-photoshop-request-zl1-hood-a1.jpg)
![](https://www.thirdgen.org/forums/attachments/signature-pictures-photoshop-requests/304766d1468999024-photoshop-request-zl1-hood-a2.jpg)
I stole your springs for this one. Your car is now un-driveable in MA:
![](https://www.thirdgen.org/forums/attachments/signature-pictures-photoshop-requests/304765d1468999024-photoshop-request-zl1-hood-a1.jpg)
![](https://www.thirdgen.org/forums/attachments/signature-pictures-photoshop-requests/304766d1468999024-photoshop-request-zl1-hood-a2.jpg)
I stole your springs for this one. Your car is now un-driveable in MA:
![](https://www.thirdgen.org/forums/attachments/signature-pictures-photoshop-requests/304767d1468999024-photoshop-request-zl1-hood-a3.jpg)
#4
Re: photoShop request (ZL1 hood)
PurelyPMD,
I thought about that idea, it looks nice on your car but in a perfect world, I really want the ZL1 insert on my car.
KMK454,
thank you! It will be difficult to graft the center section of a gen 5 hood onto a stock thirdgen hood. The 5th gens hoods are aluminum. Im still weighing out my options. I like the Sunoco hood except for the seam that runs down the center of it. If the cowl section of the Sunoco hood was a few inches narrower then it would be perfect too.
I thought about that idea, it looks nice on your car but in a perfect world, I really want the ZL1 insert on my car.
KMK454,
thank you! It will be difficult to graft the center section of a gen 5 hood onto a stock thirdgen hood. The 5th gens hoods are aluminum. Im still weighing out my options. I like the Sunoco hood except for the seam that runs down the center of it. If the cowl section of the Sunoco hood was a few inches narrower then it would be perfect too.
Last edited by BOTTLEDZ28; 07-20-2016 at 06:09 AM.
Thread
Thread Starter
Forum
Replies
Last Post
86Trans Am
Aftermarket Product Review
6
11-10-2000 08:11 AM