Drivers side quarter panel
#1
Junior Member
Thread Starter
Join Date: May 2016
Location: San Antonio Texas
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 firebird
Engine: 305
Transmission: Auto
Drivers side quarter panel
So here's is the next part to tackle.. After reading the boards here about this issue I am wondering what caused it... There doesn't appear to be any damage to the bumper that would have caused it to push into the door. The door catches at a few spots and caused the quarter panel edges to roll.. Should I pull that part off and hammer it out or replace it ?
#2
Senior Member
iTrader: (1)
Join Date: May 2014
Location: Pittsburgh
Posts: 550
Likes: 0
Received 6 Likes
on
6 Posts
Car: 91 G92 Z28
Engine: 305 TPI
Transmission: T5
Axle/Gears: 342
Re: Drivers side quarter panel
Check the pinch weld area where the fender mounts under the car. It's possible that it was improperly jacked up there instead of the actual proper jack point causing the fender to bend and/or shift.
#3
Junior Member
Thread Starter
Join Date: May 2016
Location: San Antonio Texas
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 firebird
Engine: 305
Transmission: Auto
Re: Drivers side quarter panel
Cool beans! You know what I noticed? The drivers side front post looks bent and has some rust..
Last edited by Irishamericanld; 06-28-2016 at 02:39 PM.
#5
Junior Member
Thread Starter
Join Date: May 2016
Location: San Antonio Texas
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 firebird
Engine: 305
Transmission: Auto
Re: Drivers side quarter panel
Looked under the panel and saw that it is indeed bent up ... I'll bend it down and then see how the fit is ..
Thread
Thread Starter
Forum
Replies
Last Post
AW119 Pilot
Pacific Northwest Region
1
04-15-2016 11:03 PM