Going back to stock!
#1
Junior Member
Thread Starter
Join Date: Mar 2016
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 trans am
Engine: 305
Transmission: 700R4
Going back to stock!
I have just bought my car, 1986 trans am, lg4 automatic. PO had threw away the quadrajet and put a edlebrock on it and I have just bought another quadrajet to put back on it. So to the point. I have two electrical connectors laying on top of the intake that I thought go to the front of the carb. But after further looking into it, the one connector is a single blade/pin connector with a red wire and I can't seem to figure out where that would go. The other is a three pin which obviously goes to the front drivers side. Any help and knowledge on the wiring of these things is appreciated. Thanks!!
#4
Member
Join Date: May 2003
Location: Summerville, South Carolina
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Camaro Sport Coupe
Engine: 305 (LG4)
Transmission: 700R4
Re: Going back to stock!
Im guessing the second pic bottom left is the wire your asking about. That wire goes to a idle up solenoid. it has a plunger that will push on the the throttle arm to bump up the idle when the ac is on.
Thread
Thread Starter
Forum
Replies
Last Post