Selling my twin turbo kit.
Kit comes with two modified s10 headers
Two t3 thunder bird turbos modified by majestic turbo.
One turbo is freshly rebuilt the other has about 3000 miles on it.
Two down pipes.
One intercooler dimentions are 24,12,3 (brand new never used)
This kit put a stock iroc with stealth ram into the twelves without issuses.
Selling due to new house purchas.
Would like to get 900 bucks. Turbos cost like 600 bucks alone. but open to offers.

 

Offers?????? Possible trades.

 

please send pics to
janderson1@citistreetonline.com and
cyclerage23@yahoo.com
Do you have any of the other plumbing?
thanks.

 

I'd be interested in seeing some pics too... please send to threetwentyseven@hotmail.com

 

pics to skifur555im666@comcast.net thanks, jamie

 

please send pics to timbo121212@aol.com thanks is the cold side piping included?

 

i would also like to see some pics. Send them to bryan_camaro@hotmail.com. Is there any wastegates or BOV with the kit and is the cold piping included?

 

send me pics to xxtransxamxx@optonline.net

$$$$ in hand.

 

im like everyone else. send pics to bonenct@aol.com

 

I'd like pics too, PPRracing@comcast.net

 

Will you accept any trades? I have 2000 invested into a fully complete package of four 18" Z06 rims

 

one

 

two

 

three

 

four

 

I imigine those turbos are gone with all of the people that were interested in them, but if you could reply back eithery way that would be great.

 

Is all the piping included too????

 

All you get is what you see in the pics.

 

How much for the intercooler shipped to 25401?

 

do you have any pic's from when it was installed?

 

I will try and dig up some pics of it installed. All I can say is I dont think it will work with a/c. But as far as where the turbos sit. They sit towards the front of the motor. And are at a little bit of an angle.

 

how bout that intercooler?

 

would like to sell as a whole. Would sell seperate if some one doesnt want the intercooler.

 

If you have some pics of the setup installed that would be great.
Thanks

 

Sorry cant find pics of it on the car. All I can say is that I was running a v belt alternator and no ac.

 

This setup still for sale?

What else would be needed to complete this setup. (oil/coolant lines, piping, boost controller, wastegates, etc....)

What RPM's approx did the turbos spool on your stock iroc?

Thanks,

Shawn

 

Yes this set up is still for sale. What you would need to complete the set up.
Intercooler pipeing
Two waste gates
One blow off valve
As for a boost controller you can buy a manual for like 20 bucks off ebay.

The turbos would spool at about 2500 rps. I would see full boost at 3200 to 3400.

 

do you have the specs on the turbos?

 

sorry no I dont know what the a/r is.

 

Yes I know you can get a MBC for $20, this is why I have like a half dozen of them sitting around. (I've had a few turbo cars in the past) I was just seeing if one came with it or what.... I know you said everything in the pics but sometimes people have this stuff lying around and will include it, just checking.

So by looking at the headers the wastegate flanges are right behind the turbo flanges correct? And then what is the flange on the downpipe, egr? I'm very interested just trying to see exactly what you have.

Do you know what shipping would be to Holt, MI or Lima, OH (doesn't matter which one, whatever is cheapest)? I'd like to pick up the whole setup for like $850 shipped if you'd let it go for that.

Thanks,

Shawn

 

The flange on the down pipe is for the wastegate. The waste gate vents into the down pipe.

 

stil for sale? interested, how uch for shippin to 67037

 

60 bucks for shipping

 

Just want to make sure...these headers will bolt up to my 305 correct? I don't know if TPI heads are different and maybe this is what this setup was for thats why I'm asking...I don't know a lot about sbc's.

Also, what is the brass colored fitting for on the turbos?

Shawn

 

the turbo's are rear mount?? what make of headers are those?

 

No...I'm pretty sure you mount the headers upside down, that way the turbos are right at the front.

Shawn

 

The brass fiting is the oil drain for the turbo. This kit should work with any small block chevy.

 

Thats what I thought it was. So it would need an oil supply and return (drain) line as well for each turbo. Where did you get your oil supply from and where did you connect the drain to? And it would probably need coolant lines as well, or are these turbos not water cooled?

I'm just trying to figure out exactly everything I'll need to make this work because I am on a tight budget.

Shawn

 

Hey no problem with the questions. I got the oil supply from the oil presure sender port. I just t'ed off of that and then hooked the sending unit into the t. As for the return I had my oil pan off so I drilled holes and welded in bungs for a hose. As for coolant yeah stock the turbos had coolant running through them but I didnt. You really dont need to. If you let your car run a little after beating on the car the turbos will cool down fine. Most aftermarket turbos dont have coolant ports anyways.
Kevin

 

im interested in these please pm with final price and any other info i should need i want to know if you will trade for these.

 

Did you finally sell this kevin??

Jason

 

nope not yet

 

Will you take 900 shipped to 01824? i am very interested.

 

intercooler? Still wanna sell it?

 

If the guy above passes,how about 900 shipped to 89449?

 

Why are you not including any plumbing or intake piping or waste gates? Where is the rest of the parts? If you ran it on that Iroc, you would have the rest of the parts. To me it looks like a project that was never finished.

Dont get me wrong, this is a good deal, but something is fishy about not having the rest of the parts. Give more info to the people.
Just lookin out for fellow thirdgener's

 

Ok,
Fishy.... I dont think so. FlamedIroc is local and has seen the parts and can vouch for what I am selling. Yes the project was not finnished. I bought this turbo kit with the intention of using it on my car. Well fundage for my car is not good enough to do what I want. There is to much my car needs to worry about the turbo kit. Thus the reason I am selling it. The person I bought it from built a huge turbo kit thus he kept the intercooler and some of the parts for the turbo kit he was using. I paid way more for this then what I am selling it for. I just want to drive my car again.
Fishy, I dont think so. I have been a part of thirdgen.org for a while now. I dont screw people over. Ask anyone who has delt with me.
----------
Sorry I sold the intercooler all ready.

 

would you sell jsut the headers? if so how much shipped to 91406?

 

still go tthe turbos and the headers?

 

Still have the turbos and headers. Really dont want to seperate.