Profab/k-member/w-motor Mounts
#1
Profab/k-member/w-motor Mounts
I have a NEW PROFAB MILD STEEL W/ MOTOR MOUNT PADS/ AND ITS SETUP FOR COIL OVERS.
This is a NEW member, it was in my car for ten hours, when I decided to go all the way and switch to a rack & pinion.
I want 200.00 you pay the shipping.
Profab is selling this item for 380.00
THIS IS POWDER COATED RED. The bolt holes are marked, other than that its perfect.
Email me if your interested: johnpinkos69@yahoo.com
This is a NEW member, it was in my car for ten hours, when I decided to go all the way and switch to a rack & pinion.
I want 200.00 you pay the shipping.
Profab is selling this item for 380.00
THIS IS POWDER COATED RED. The bolt holes are marked, other than that its perfect.
Email me if your interested: johnpinkos69@yahoo.com
#5
It will fit!
http://www.profabracing.homestead.com/
These guys have done a great job for me!
I have my setup now with the rack & pinion(flaming river), and I went with there control arms and coil over kit, lakewood 90/10 drag struts, new upper flange kit from Spohn Perfomance, my bearings where stock and sticky, the rubbers where dry.
Being yours is a topless should not matter at all!
Thanks
Later
Rotten
These guys have done a great job for me!
I have my setup now with the rack & pinion(flaming river), and I went with there control arms and coil over kit, lakewood 90/10 drag struts, new upper flange kit from Spohn Perfomance, my bearings where stock and sticky, the rubbers where dry.
Being yours is a topless should not matter at all!
Thanks
Later
Rotten
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:49 AM