10.95 @ 124.83
#1
10.95 @ 124.83
Finally ran tens last weekend.
My sixty sucked it was a 1.63
I am suprised I even went that fast my combo this year was terrible. My exhuast system especially my headers are way to small for my motor.
I have the flowtech 1.55 primary shorty headers. I am buying the hooker super comps and running a dual 3.5 inch next year along with a bigger cam.
So hopefully nexy year I will be in the low tens where this motor on the nitrous should be!
I went 10.95 on a 150 this year. Thanks for all the help this message board is a great resource for third gen info!
Thanks
My sixty sucked it was a 1.63
I am suprised I even went that fast my combo this year was terrible. My exhuast system especially my headers are way to small for my motor.
I have the flowtech 1.55 primary shorty headers. I am buying the hooker super comps and running a dual 3.5 inch next year along with a bigger cam.
So hopefully nexy year I will be in the low tens where this motor on the nitrous should be!
I went 10.95 on a 150 this year. Thanks for all the help this message board is a great resource for third gen info!
Thanks
#2
Supreme Member
iTrader: (1)
Joined: Apr 2002
Posts: 4,671
Likes: 0
From: Waterloo, Iowa
Car: 86 firebird with 98 firebird interi
Engine: pump gas 427sbc Dart Lil M 13.5:1
Transmission: Oldani TH400 w/ BTE 9" convertor
Axle/Gears: 31 spline Moser/full spool/4.11Rich
I've found after numerious wheelies this yr, the super comps take one hellava beating with the A-arms slamming into them once you've left the ground I have 2 tubes on the pass side and drivers side that will need patched before next yr for sure. Either that or thinking maybe front end limiters.
#3
Supreme Member
Joined: Jul 1999
Posts: 1,011
Likes: 0
From: Saskatoon, Saskatchewan, Canada
Car: 86 Trans Am
Engine: 406
Transmission: TH350, 4200
Axle/Gears: Moser 9", 3.89
Congratulations on the 10 second pass.
Is there still talk to Gimli not being open next year?
Is there still talk to Gimli not being open next year?
Thread
Thread Starter
Forum
Replies
Last Post
Ronny
Alternative Port EFI Intakes
4
07-09-2015 01:26 PM